1Setting Up
Using the GPIB Interface
1Connect a GPIB cable from the controller PC’s GPIB interface to the “GPIB” port on the back of the oscilloscope.
2On the oscilloscope, verify that the controller interface is enabled: a Press the Utility button.
b Using the softkeys, press I/O and Controller.
c Ensure the box next to GPIB is selected(). If not(), use the Entry knob to select GPIB; then, press the Control softkey again.
3Configure the oscilloscope’s GPIB interface:
a Press the Configure softkey until “GPIB” is selected. b Use the Entry knob to select the Address value.
10 | Agilent 6000 Series Oscilloscopes Programmer’s Quick Start Guide |