Electrolux AG15538A manual Battery, Other, Fuel System, Engine OIL, Cylinders

Page 27

STORAGE

Immediately prepare your tractor for stor- age at the end of the season or if the trac- tor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

1.Clean entire tractor (See “CLEANING” in the Maintenance section of this manual).

2.Inspect and replace belts, if necessary (See belt replacement instructions in the Service and Adjustments section of this manual).

3.Lubricate as shown in the Maintenance section of this manual.

4.Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

5.Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

•Fully charge the battery for storage.

•After a period of time in storage, battery may require recharging.

•To help prevent corrosion and power leakage during long periods of storage, battery cables should be disconnected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Maintenance section of this manual).

•After cleaning, leave cables discon- nected and place cables where they cannot come in contact with battery terminals.

•If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: It is important to prevent gum deposits from forming in essential fuel system parts such as carburetor, fuel hose, or tank during storage. Also, alcohol

blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can dam- age the fuel system of an engine while in storage.

•Empty the fuel tank by starting the en- gine and letting it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or stor- age container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the car- buretor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

1.Remove spark plug(s).

2.Pour one ounce of oil through spark plug hole(s) into cylinder(s).

3.Turn ignition key to start position for a few seconds to distribute oil.

4.Replace with new spark plug(s).

OTHER

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your tractor indoors and cover it to give protection from dust and dirt.

•Cover your tractor with a suitable pro- tective cover that does not retain mois- ture. Do not use plastic. Plastic cannot breathe which allows condensation to

form and will cause your tractor to rust. IMPORTANT: Never cover tractor while engine and exhaust areas are still warm.

27

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Model NO. AG15538A Warranty Table of ContentsSafety Rules General OperationII. Slope Operation IV. Service III. ChildrenDo not Safety Rules Customer Responsibilities Product SpecificationsUnassembled Parts Before Removing Tractor from Skid Tools Required for AssemblyHOW to SET UP Your Tractor To Remove Tractor from CartonCheck Battery Check Deck Levelness ChecklistCheck Tire Pressure Check for Proper Position of ALL BeltsOperation Know Your Tractor Light Switch Position Turns the headlights on and offHOW to USE Your Tractor Before Starting the Engine ADD Gasoline To Start EngineMowing Tips Maintenance General Recommendations Lubrication ChartBefore Each USE Tractor Belts Clean AIR ScreenEngine Transaxle CoolingSpark Plugs CleaningAIR Filter MufflerService and Adjustments To Install MowerTo Remove Mower SIDE-TO-SIDE Adjustment To Level Mower HousingTo Replace Mower Blade Drive Belt To Check and Adjust BrakeTo Remove Wheel for Repairs To Adjust Steering Wheel ALIGN- MentTo Replace Motion Drive Belt Front Wheel TOE-IN/CAMBERTo Remove CABLES, Reverse Order Replacing BatteryTo Start Engine with a Weak BAT- Tery To Attach Jumper CablesTo Adjust Carburetor Engine OIL BatteryOther Fuel SystemProblem Cause Correction Troubleshooting ChartExcessive Poor grass Suggested Guide for Sighting Slopes for Safe Operation

AG15538A specifications

The Electrolux AG15538A is a vacuum cleaner designed to cater to the needs of modern households, combining advanced technology with user-friendly features to provide efficient cleaning. This model is part of Electrolux's extensive range known for its reliability, efficiency, and innovative design.

One of the standout features of the AG15538A is its powerful motor, delivering impressive suction capabilities. This ensures that it can easily pick up dirt, dust, and debris from various surfaces, including carpets, hardwood floors, and tiles. The vacuum's suction power is complemented by its efficient filtration system, which captures allergens and fine dust particles, making the home environment healthier and more comfortable.

The vacuum cleaner incorporates a multi-cyclonic technology, which helps to separate dirt and air, ensuring that suction power remains consistent even as the dust container fills up. This feature not only enhances cleaning efficiency but also reduces maintenance, as the filters require less frequent replacement. Additionally, the bagless design allows for easy disposal of collected dirt, reducing the hassle of bag replacements and contributing to convenience.

The AG15538A is designed for ease of use, featuring an ergonomic handle and lightweight construction that make it easy to maneuver around furniture and reach high places. Its adjustable suction settings allow users to customize the cleaning experience based on the type of surface being cleaned, ensuring optimal performance on all floor types.

Another notable characteristic of this vacuum is its quiet operating system. Despite its powerful suction, the AG15538A operates at a much lower noise level compared to traditional vacuum cleaners, allowing for peaceful cleaning without disturbing other household members.

In terms of storage, the vacuum is compact, making it easy to stow away when not in use. Its longer cord also adds to the convenience, allowing users to clean larger areas without frequently changing outlets.

Overall, the Electrolux AG15538A combines modern technology with thoughtful design, making it a reliable choice for households looking for a powerful, efficient, and easy-to-use vacuum cleaner. Its advanced features reflect Electrolux’s commitment to creating innovative home appliances that enhance everyday living.
Top Page Image Contents