Craftsman 917.270512 owner manual To Adjust STEERINGWHEELALIGN- Ment, To Start Engine with a Weak

Page 24

TO ADJUST STEERINGWHEELALIGN- MENT

If steering wheel crossbarsare not hori-

zontal (left to right) when wheels are posi- tioned straight forward, remove steering wheel and reassemble per instructions in the Assembly section of this manual.

FRONT WHEEL TOE-IN/CAMBER

The front wheel toe-in and camber are not

adjustable on your tractor. If damage has occurred to affect the front wheel toe-in or

camber, contact your nearest authorized service center.

TO REMOVE WHEEL FOR REPAIRS

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not

lose).

•Repair tire and reassemble.

•On rearwheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts

dealer. Tire sealant also prevents tire dry rot and corrosion.

Washers

Axle

Square Key .___..__'

(Rear Wheel Only)

TO START ENGINE WITH A WEAK

BATTERY

4,CAUTION: Lead-acid batteries gener- ate explosive gases. Keep sparks, flame and smoking materials away from batter- ies. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATrERY" in the MAINTENANCE sec- tion of this manual).

If ,jumper cables" are used for emergency starting, follow this procedure:

IMPORTANT: Your tractor Is equipped with a 12 volt negative grounded system.

The other vehicle must also be a 12 volt negative grounded system. Do not use your tractorbattery to start other vehicles.

TO ATTACH JUMPER CABLE_3- _

"°

•Connect each end of the RED cable to the POSITIVE (+) terminal of each bat-

tery, taking care not to short against chassis.

•Connect one end of the BLACK cable to

the NEGATIVE (-) terminal of fully charged battery.

•Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery.

TO REMOVE CABI'ES,REVERSE

ORDER -

•BLACK cable first irom chassis and then from the fully charged battery.

•RED cable last from both batteries.

Positive

TerminalTermirBl

Charged

 

Battery

Negative

 

Positive Terminal

Terminal

 

REPLACING BATTERY

ACAUTION: Do not short battery ter- minals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wrist-

watch bands, rings,etc.

Positive terminal must be connected first to prevent sparking fromaceiden- tal grounding.

•Lift seat pan to raised position and open battery box door.

•Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•First connect RED battery cable to posi- tive (+) terminal with hex bolt and keps nut as shown. Tighten securely.

•Connect BLACK grounding cable to negative (-) terminal with remaining hex belt and keps nut. Tighten securely.

•Close battery box door.

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Raftzman + Limited 90 DAY Warranty on Battery Parts OrderingGeneral Operation Service Slope OperationDo not ChildrenManufacturersrecommended pa when necessary TY is InvolvedProduct Specifications Maintenance AgreementPage Parts packed separately in carton Assembly Tools Required ForTo Remove Tractor from CartonHOW to SET UP YOUR-TRACTOR Check Battery Install SeatChecklist Please Review the Followinp Checklist Check Tire PressureCheck Deck Levelness Check for Proper Position ALL BeltsH L Know Your Tractor HOW to USE Your Tractor Before Starting the Engine ADD GasolineCold Weather Starting 50 F Below To Start EngineMowing Tips Lubrication Chart General RecommendationsCustomer RESPONSIBlUTIESBattery Brake OperationTires Operator Presence SystemBelts Transaxle CoolingEngine AIR FilterCleaning Engine Cooling FinsTo reassemble, reverse above proce- dure To Install Mower Raise attachment lift lever to its highes positionTo Remove Mower To Level Mowerhousing SIDE-TO-SIDEADJUSTMENTTo Replace Mower Blade Drive Belt Installation Install new belt in reverse order of removalTo Adjust Brake To Adjust STEERINGWHEELALIGN- Ment Replacing BatteryTo Start Engine with a Weak To Attach Jumper CABLE3To Adjust Throttle Control Cable To Remove Hood and Grill AssemblyTo Replace HEADLIG.HT Bulb Interlocks and RelaysToadjust Carburetor Preliminary SettingFinal Setting Acceleration TestTractor OtherFuel System Engine OILTroubleshooting Chart Problem Troubleshooting Problem Chart CauseCorrection Dirty engine air screen/fins Dirty/cloggedmufflerTroubleshooting Chart Problemcause SlowPage Page Schematic Tractor - Model NumberTractor -- Model Number Electrical Electrical DescriptionTractor - Model Number Chassis and Enclosures Tractor - Model Number 917.270512 Chassis and Enclosures Tractor -- Model Number Ground Drive Tractor - Model Number Ground Drive KEY Part DescriptionSteering Assembly Tractor - Model Number Steering Assembly RingKlip#T5304-75Engine Tractor --MODEL NumberOptional Equipment Tractor - Model Number Tractor - Model Number Seat Assembly Decals Wheels & TiresTractor - Model Number Lift Assembly Shaft Asm Lift Tractor - Model Number Mower Deck #10-24 Grade 35A Part Description 23O 13z1 /lO4 Gasket SET 615 Label KITCap Washer,SpringSeal Assembly,Valve Page Iii Sears

917.270512 specifications

The Craftsman 917.270512 is a robust and versatile lawn tractor that combines power, performance, and precision to help homeowners maintain their yards efficiently. This model, part of Craftsman’s renowned line of outdoor power equipment, is designed for a variety of lawn care tasks, from mowing to hauling, making it an ideal choice for those with medium to large lawns.

One of the standout features of the Craftsman 917.270512 is its powerful engine. Equipped with a 22 horsepower Briggs & Stratton engine, this tractor provides reliable performance and ample power to tackle thick grass and uneven terrain. The engine is designed for easy starting and smooth operation, ensuring that users can get to work quickly without the frustration of complicated starting procedures.

The cutting deck on the Craftsman 917.270512 is another key feature. With a 42-inch deck, this lawn tractor offers a wider cutting path, allowing users to cover more ground in less time. The deck is also adjustable, giving the operator the flexibility to customize cutting heights between 1.5 and 4 inches, ensuring an even and well-manicured lawn. Additionally, the deck is designed with a washout port, making it easy to clean and maintain after use.

In terms of technology, the Craftsman 917.270512 incorporates a hydrostatic transmission that provides smoother acceleration and ease of operation. This type of transmission allows the operator to change speeds seamlessly without the need for manual shifting, making it simpler to navigate various terrains effortlessly. This feature is particularly beneficial for maneuvering around obstacles and tight spaces in the yard.

Comfort is a key consideration in the design of the Craftsman 917.270512. It features an ergonomic seat with ample cushioning, ensuring that the operator remains comfortable even during extended mowing sessions. The tractor's compact size also allows for easy navigation in smaller spaces, while the responsive steering enhances maneuverability.

Furthermore, the Craftsman 917.270512 is equipped with a robust set of safety features, including a safety switch that ensures the engine stops when the operator leaves the seat. This feature significantly reduces the risk of accidents, making it a safe choice for users of all ages.

In summary, the Craftsman 917.270512 lawn tractor is a powerful and versatile equipment option for homeowners seeking an efficient lawn care solution. Its reliable engine, adjustable cutting deck, hydrostatic transmission, and user-friendly design make it an excellent investment for maintaining your lawn. With the right combination of performance, comfort, and safety, the Craftsman 917.270512 is sure to be a valuable addition to your outdoor toolkit.
Top Page Image Contents