Gardena 1559 manual Operation, Incorrect location, Select watering sector, Roughly select sector

Install Large-Area Pop-Up Irrigation:

8 7 9

Remove protective plastic film of solar cell:

Incorrect location:

1 :

●No obstacles (e.g. walls, trees, etc.) should be located in the watering sector. It must be possible to access every contour point of the areas to be watered in a straight line. With the maximum range the spray height can reach approx. 5 m.

2 :

●The minimum range is 2.5 m (at 2 bar). With circle water distribution the large-area pop-up irrigation must therefore be located 2.5 m from the edge in all directions (A). If this is not possible the large-area pop-up irrigation should be positioned at the edge and the watering area will be a circle sector ( B).

Before installing the large-area pop-up irrigation, you must set up an above-ground test to check whether the large- area pop-up irrigation can actually water the required area at this location.

The large-area pop-up irrigation has a 3/4 ” female thread and is connected to the 25 mm Connecting Pipe 8 Art. 2700 / 2701 using the GARDENA L-piece 7 Art. 2781.

1.Install the above-ground test set-up and check whether the large-area pop-up irrigation can water the required area (see 5. Operation).

2.If the large-area pop-up irrigation has watered the required area in the test, install a pack of coarse gravel 9 approx. 20 cm x 20 cm x 20 cm in size underneath the unit.

This ensures proper functioning of the drain valve.

3.Install the upper edge of the large-area pop-up irrigation level with the turf. This prevents any damage when mowing the lawn.

vTake off transportation protective plastic film from the protective panel of of the solar cell.

GB

5. Operation

Select watering sector:

0

L zR

A watering sector from 25° to 360° can be selected. To prevent areas being watered unintentionally (e.g. house), the sector should first be selected roughly (slightly too small).

Roughly select sector:

1.Close water supply.

2.Turn the nozzle head 0 by hand to the middle of the watering sector (e.g. P4).

3.Roughly select watering sector: turn right sector stop zR to right-hand side (e.g. P9) and left sector stop zL to left-hand side (e.g. P2).

Re-adjust sector:

1.Open water supply.

2.Watch watering sector and re-adjust the sector-stops zL and zR according to the sector limits (P1 and P10) until the change in direction matches the required irrigation limits.

If watering in a complete circle, the two sector stops zL and zR must be completely pushed together between P1 and P10.

13