Check for Proper Position of ALL Belts

INSTALL MULCHER PLATE

1.Raise and hold deflector shield in upright position.

2.Place front of mulcher plate over front of mower deck opening and slide into place, as shown.

3.Hook front latch into hole on front of mower deck.

4.Hook rear latch into hole on back of mower deck.

_ICAUTION: Do not remove deflector shield from mower.

Latch

Hooks

TO CONVERTTO BAGGING OR

Simply remove mulcher plate and store in

a safe place. Your mower is now ready for discharging or installation of optional grass

catcher accessory.

NOTE: It is not necessary to change blades. The mulcher blades are designed

for discharging and bagging also.

The tires on your tractor were overin- flated at the factory for shipping purposes. Correct tire pressure is important for best cutting performance.

Reduce tire pressure to PSI shown in "PRODUCT SPECIFICATIONS" section of this manual.

For best cutting results, mower hous-

ing should be properly leveled. See "TO LEVEL MOWER HOUSING" in the Service

and Adjustments section of this manual.

See the figures that are shown for replac- ing motion and mower blade drive belts

in the Service and Adjustments section of this manual. Verify that the belts are routed correctly.

After you learn how to operate your trac- tor, check to see that the brake is properly adjusted. See "TO ADJUST BRAKE" in

the Service and Adjustments section of this manual.

Before you operate and enjoy your new tractor, we wish to assure that you receive the best performance and satisfaction from this Quality Product.

Please review the following checklist: ,/All assembly instructions have been

completed.

,/No remaining loose parts in carton. ,/Battery is properly prepared and

charged. (Minimum 1 hour at 6 amps). ,/Seat is adjusted comfortably and tight-

ened securely.

,/All tires are properly inflated. (For ship- ping purposes, the tires were overin- flated at the factory).

,/Be sure mower deck is properly leveled side-to-side/front-to-rear for best cutting results. (Tires must be properly inflated for leveling).

,/Check mower and drive belts. Be sure they are routed properly around pulleys and inside all belt keepers.

,/Check wiring. See that all connections are still secure and wires are properly clamped.

While learning how to use your tractor, pay

extra attention to the following important items:

€" Engine oil is at proper level.

€" Fuel tank is filled with fresh, clean, regu- lar unleaded gasoline.

€" Become familiar with all controls - their location and function. Operate them before you start the engine.

€" Be sure brake system is in safe oper- ating condition.