5.Pivot seat and pan forward and as- semble adjustment knob and flat washer loosely. Do not tighten.
6.Lower seat into operating position and sit in seat.
7.Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down.
8.Get off seat without moving its ad- justed position.
9.Raise seat and tighten adjustment knob securely.
Seat
Seat I
Shoulder
Bolts
Flat Washer
Adjustment Knob
CHECK BATTERY
1.Lift seat pan to raised position. NOTE: If this battery is put into service
after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at
Seat
Terminal
NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.
TO ROLL TRACTOR OFF SKID (See
Operation section for location and
function of controls)
1.Press lift lever plunger and raise
attachment lift lever to its highest po- sition.
2.Release parking brake by depressing clutch/brake pedal.
3.Place gearshift lever in neutral (N) position.
4.Roll tractor forward off skid.
5.Remove banding holding deflector shield up against tractor.
TO DRIVE TRACTOR OFF SKID (See
Operation section for location and
function of controls)
_WARNING: Before starting, read, un- derstand and follow all instructions in the
Operation section of this manual. Be sure tractor is in a
the area in front of tractor is clear of other people and objects.
1.Be sure all the above assembly steps have been completed.
2.Check engine oil level and fill fuel tank with gasoline.
3.Sit on seat in operating position, depress clutch/brake pedal and set the parking brake.
4.Place gear shift lever in neutral (N) position.
5.Press lift lever plunger and raise
attachment lift lever to its highest posi- tion.
6.Start the engine. After engine has started, move throttle control to idle position.
7.Depress clutch/brake pedal into full "BRAKE" position and hold. Move gear- shift lever to 1st gear.
8.Slowly release clutch/brake pedal and slowly drive tractor off skid.
9.Apply brake to stop tractor, set park- ing brake and place gearshift lever in neutral position.
10.Turn ignition key to "STOP" position. Continue with the instructions that follow.
9