TO LEVEL MOWER HOUSING
Adjust the mower while tractor is parked on level ground or driveway. Make sure
tires are properly inflated (See "PROD-
UCT SPECIFICATIONS" section of this
manual). If tires are over or underinflated, you will not properly adjust your mower.
SIDE-TO-SIDE ADJUSTMENT
Raise mower to its highest position.
•At the midpoint of both sides of mower, measure height from bottom edge of
mower to ground. Distance "A" on both sides of mower should be the same or
within 1/4" of each other.
If adjustment is necessary, make adjust- ment on one side of mower only.
•To raise one side of mower, tighten lift link adjustment nut on that side.
•To lower one side of mower, loosen lift
link adjustment nut on that side.
NOTE: Each full turn of adjustment nut will change mower height about 1/8".
Recheck measurements after adjusting.
Bottom edge |
| Bottom edge of |
of mower to _ | __er | to ground |
0 oun0 | 7 | |
A_L | "_V Ground Ijne_ | |
Arm
•When distance "D" is 1/8" to 1/2"
lower at front than rear, tighten nuts "F" against trunnion on both front links.
•To raise front of mower, loosen nut "F" from trunnion on both front links. Tighten nut "E" on both front links an equal num- ber of turns. The two front links must remain equal in length.
•When distance "D" is 1/8" to 1/2" lower
at front than rear, tighten nut "F" against trunnion on both front links.
Recheck
'D.... D"
Both Front._nks Should beE.qual in Length
Nut
LiftjuListrmkent N_
FRONT-TO-BACK ADJUSTMENT
IMPORTANT: Deck must be level
front links equally so mower will stay level
To obtain the best cutting results, the mower housing should be adjusted so
that the front is approximately 1/8" to 1/2" lower than the rear when the mower is in
its highest position.
Check adjustment on right side of trac- tor. Measure distance "D" directly in front and behind the mandrel at bottom edge of mower housing as shown.
Before making any necessary adjust- ments, check that both front links are equal in length.
If links are not equal in length, adjust one link to same length as other link.
•To lower front of mower loosen nut "E"
on both front links an equal number of turns.
Front Links
TO REPLACE MOWER BLADE DRIVE
BELT
The mower blade drive belt may be re- placed without tools. Park the tractor on level surface. Engage parking brake.
BELT REMOVAL -
1.Remove mower from tractor (See "TO REMOVE MOWER" in this section of
manual).
2.Work belt off both mandrel pulleys and idler pulleys.
3.Pull belt away from mower,
BELT INSTALLATION -
1.Work belt around both mandrel pulleys and idler pulleys
2.Make sure belt is in all pulley grooves and inside all belt guides.
3.Install mower (See "To Install Mower" in this section of this manual).
22