Craftsman 917.274953 manual To Transport, Towing Carts and Other Attach Ments, ADD Gasoline

TO TRANSPORT

•Raise attachment lift to highest position with attachment lift control.

•When pushing or towing your tractor, be

sure gearshift lever is in neutral (N) posi- tion.

•Do nct push ortowtrector at morathanfive

(5) MPH.

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

TOWING CARTS AND OTHER ATTACH-

MENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your tractor. Use common sense when towing.

Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with

the ground and cause you to lose control of your tractor.

BEFORE STARTING THE ENGINE CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

1.Check engine oil with tractor on level ground.

2.Unthread and remove oil fill cap/ dipstick; wipe oil off. Reinsert the dipstick into the tube and rest oil fill cap on the tube. Do not thread the cap onto the tube. Remove and read oil level. If necessary, add oil until =FULL" mark on dipstick is reached.

Do not overfill.

•For cold weather operation you should

change oil for easier starting (See =OIL VISCOSITY CHAR'I"in the Mainte-

nance section of this manual).

•To change engine oil, see the Mainte- nance section in this manual.

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do

not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide

deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or
fuel. Do not store, spill or use gasohne
near an open flame.	14

IMPORTANT: When operating in temperatures below32°F(0°C), use fresh, clean winter grade gasoline to help insure good cold weather starting.

CAUTION: Alcohol blended fuels

(called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids dudng storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructionsfor additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE

When starlingthe enginefor_ firsttime or if the enginehas runout offuel, itwilltake extra cranldngtime to rnovefuel fromthe tank to the engine.

1.Sit on seat in operating position, depress clutch/brake pedal and set parking brake.

2.Place gear shift lever in neutral (N) position.

3.Move attachment clutch to disen-

gaged position.

4.Move throttle control to fast position

5.Pull choke control out for a cold engine start attempt. For a warm

engine start attempt the choke control may not be needed.

NOTE: BeforestarUng,readfile warm and cold slar'dngproceduresbelow.

6.Insert key into ignition and turn key clockwise to start position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, push choke control in, wait a

few minutes and try again. If engine still does not start, pull the choke

control out and retry.

WARM WEATHER STARTING (50° F and above)

7.When engine starts, slowly push choke control in until the engine begins to run smoothly. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in slowly.