Craftsman 917.274953 manual Muffler, Spark Plugs, IN-LINE Fuel Filter

ENGINE OIL FILTER

Replace the engine oil filter every season or every other oil change if the tractor is used more than 100 hours in one year.

AIR FILTER

Your engine will not run properly using a dirty air filter. Clean the foam pre-cleaner after every 25 hours of operation or every season. Service paper cartridge every 100 hours of operation or every season, whichever occurs first.

Service air cleaner more often under dusty conditions.

1.Loosen knob and remove cover.

TO SERVICE PRE-CLEANER

2.Slide foam pre-cleaner off cartridge.

3.Wash it in liquid detergent and water.

4.Squeeze it dry in a clean cloth. Allow

it to dry.

5, Saturate it in engine oil. Wrap it in

clean, absorbent cloth and squeeze to remove excess oil.

TO SERVICE CARTRIDGE

•Replace a dirty, bent, or damaged cartridge.

NOTE: Do not wash the paper cartridge or use pressurized air, as this will damage the cartridge.

1.Remove nut and cartridge plate.

2.Reinstall the pre-cleaner (cleaned and oiled) over the paper cartridge.

3.Check rubber seal for damage and proper position around stud. Replace if necessary.

4.Reassemble air cleaner, cartridge plate, and nut.

5.Reinstall air cleaner cover and secure by tightening knob.

Certdd

Foam

Pro-Cleaner

Cartridge

Every 100 hours of operation (more often under extremely dusty, dirty conditions), remove the blower housing and other cooling shrouds. Clean the cooling fins and external surfaces as necessary. Make sure the cooling shrouds are reinstalled. NOTE: Operating the engine with a blocked grass screen, dirty or plugged cooling fins, and/or cooling shrouds removed will cause engine damage due to overheating.

MUFFLER

Inspect and replace corroded muffler and spark arrsster (if equipped) as it could create a fire hazard and/or damage.

SPARK PLUG(S)

Replace spark plug(s) at the beginning of each mowing season or after every 100 hours of operation, whichever occurs first.

Spark plug type and gap setting are shown in "PRODUCT SPECIFICATIONS"

section of this manual.

IN-LINE FUEL FILTER

The fuel filter should be replaced once each season. If fuel filter becomes

clogged, obstructing fuel flow to carbure- tor, replacement is required.

1.With engine cool, remove filter and plug fuel line sections.

2.Place new fuel filter in position in fuel

line with arrow pointing towards carburetor.

3.Be sure there are no fuel line leaks and clamps are properly positioned.

4.Immediately wipe up any spilled gasoline.

Fuel Filter---__ _1

CLEANING

Knob'

Rubber

Seal

Nut

• Clean engine,				battery, seat,		finish,	etc.
	of	all foreign matter.
•	Keep		finished	surfaces	and	wheels	free
	of	all	gasoline, oil, etc.
•	Protect painted			surfaces	with automo-

CLEAN AIR SCREEN

Air screen must be kept free of dirt and chaff to prevent engine damage from overheating. Clean with a wire brush or compressed air to remove dirt and stubborn dried gum fibers.

CLEAN AIR INTAKE/COOLING AREAS

To insure proper cooling, make sure the grass screen, cooling fins, and other external surfaces of the engine are kept clean at all times.

tive type wax.

We do not recommend using a garden hose to clean your tractor unless the aisctrical system, muffler, air filter and carburetor are covered to keep water out. Water in engine can result in a shortened engine life.

19