Craftsman 917.27475 manual Engine, Battery, Transaxle Cooling

Page 19

balancer.)

NOTE: Do notuse a nail for balancing blade. The lobes of the center hole may appearto be centered,butare not.

•Slide bladeon to an unthreadedportion of the steel bolt or pin and hold the bolt or pin parallelwith the ground. If blade is balanced,it should remainin a horizontalposition. If either end of the blade movesdownward,sharpenthe heavyend untilthe blade danced.

Blade

5/8" Bolt or Pin

Center Hole

BATTERY

Your tractor has a battery charging system which is sufficient for normal use. How-

ever, periodic charging of the battery with an automotive charger will extend its life.

•Keep battery and terminals clean.

•Keep battery bolts tight.

•Keep small vent holes open.

•Recharge at 6-10 amperes for 1 hour. NOTE: The original equipment battery on your tractor is maintenance free. Do not

attempt to open or remove caps or covers. Adding or checking level of electrolyte is not necessary.

TO CLEAN BATTERY AND TERMINALS

Corrosion and dirt on the battery and terminals can cause the battery to "leak" power.

1.Disconnect BLACK battery cable first then RED battery cable and remove battery from tractor.

2.Rinse the battery with plain water and dry.

3.Clean terminals and battery cable ends with wire brush until bright.

4.Coat terminals with grease or petro- leum jelly.

5.Reinstall battery (See "REPLACING BATTERY" in the SERVICE AND AD-

JUSTMENTS section of this manual).

TRANSAXLE COOLING

Keep transaxle free from build-up of dirt and chaff which can restrict cooling.

V-BELTS

Check V-belts for deterioration and wear after 100 hours of operation and replace if necessary. The belts are not adjustable. Replace belts if they begin to slip from wear.

ENGINE

LUBRICATION

Only use high quality detergent oil rated with API service classification SG-SL.

Select the oil's SAE viscosity grade according to your expected operating temperature.

SAE VISCOSITY GRADESt

4_I

NOTE: Although multi-viscosity oils

(5W30, 10W30 etc.)improve starting in cold weather, they will result in increased oil consumption when used above 32°F.

Check your engine oil level more frequent- ly to avoid possible engine damage from running low on oil.

Change the oil after every 50 hours of op- eration or at least once a year if the tractor is not used for 50 hours in one year.

Check the crankcase oil level before start- ing the engine and after each eight (8) hours of operation. Tighten oil fill cap/

dipstick securely each time you check the oil level.

TO CHANGE ENGINE OIL

Determine temperature range expected before oil change. All oil must meet API

service classification SG-SL.

•Be sure tractor is on level surface.

•Oil will drain more freely when warm.

•Catch oil in a suitable container.

1.Remove oil fill cap/dipstick. Be careful not to allow dirt to enter the engine

when changing oil.

2.Remove yellow cap from end of drain valve and install the drain tube onto the

fitting.

Oil Drain Valve

3.Unlock drain valve by pushing inward slightly and turning counterclockwise.

4.To open, pull out on the drain valve.

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Crrftsmrn Limitedwarrantyon Craftsmanridingequipment General Operation Safe Handling of Gasoline ServiceIII. Children IV. TowingGeneral Service Product Boot To Remove Tractor from Carton Assemble Extension Shaft and BootInstall Steering Wheel Install SeatTo Roll Tractor OFF Skid See Operation section for location Check BatteryCheck for Proper Position of ALL Belts ChecklistCheck Tire Pressure Check Deck LevelnessAutomatic Models only ROS on Know Your TractorTo SET Parking Brake HOW to USE Your TractorStopping To Operate Mower Using the Reverse Operation SystemReverse Operation System ROS To Operate on Hills Mowing Tips Lubrication ChartGeneral Recommendations Before Each USETo Sharpen Blade Engine BatteryTransaxle Cooling Engine Cooling System Clean AIR ScreenEngine OIL Filter AIR FilterIN-LINE Fuel Filter CleaningMuffler Spark PlugsTractor To Remove Mower To Install MowerTo Replace Mower Blade Drive Belt To Level Mower HousingTo Replace Motion Drive Belt To Check and Adjust BrakeTo Adjust Brake To Check BrakeTo Start Engine with a Weak BAT Tery MentReplacing Battery Engine Other TractorEngine OIL CylindersStart Engine Troubleshooting ChartCause 3ORRECTION ChokedCause ProblemCorrection OFF Problem CausePage Tractor - Model Number SchematicElectrical KEY Part NO. NO.DESCRIPTION Tractor - Model Number Chassis and Enclosures KEY Part Description Tractor Model Number Ground Drive Stlt Tractor - Model Number Ground DriveTractor - Model Number Steering Assembly Tractor - Model Number Steering Assembly Optional Equipment Tractor - Model Number Lift Assembly Tractor - Model Number Seat Assembly Decals Tractor - Model Number Mower Deck Shaft 42A REF Part NO. no Description 20@ 305% O47 Briggs ENGINE-MODEL Number 31P777, Type Number 0299-E1 917.274750Tractor Model Number Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationSears

917.27475 specifications

The Craftsman 917.27475 is a lawn tractor that combines power, performance, and versatility, making it an ideal choice for homeowners looking to maintain their outdoor spaces with ease. Equipped with a robust 19 horsepower Briggs & Stratton engine, this model provides reliable starting and efficient performance, ensuring that tackling those large lawns becomes a manageable task.

One of the standout features of the Craftsman 917.27475 is its 42-inch cutting deck, which offers a wide cutting path to handle various terrains. The deck is made of high-quality steel, ensuring durability and a long lifespan. This model also boasts an adjustable cutting height, allowing users to select from various settings to achieve the desired lawn appearance, whether it be a manicured finish or a more natural look.

The tractor's six-speed manual transmission offers users complete control over their mowing speed, enabling them to adjust according to their mowing conditions. Its tight turning radius allows for enhanced maneuverability, making it easier to navigate around flower beds, trees, and other landscaping features, ensuring a clean cut every time.

Comfort is another key feature of the Craftsman 917.27475. It comes with a plush, high-back seat that provides ample support, helping to reduce fatigue during longer mowing sessions. The strategically placed steering wheel and foot pedals ensure that controls are easily accessible, contributing to an enjoyable mowing experience.

Another advantage of this lawn tractor is its versatility. The Craftsman 917.27475 can accommodate various attachments, transforming it into a multi-purpose machine. Whether it's adding a bagger for easy grass collection, a mulching kit for nutrient recycling, or a snow blade for winter use, this tractor can adapt to changing seasonal needs.

Additionally, the model features an easy-to-access fuel tank and a simple maintenance design that allows for hassle-free oil changes and adjustments. With its durable tires designed for traction on various terrains, the Craftsman 917.27475 is built to tackle all types of mowing challenges.

In summary, the Craftsman 917.27475 lawn tractor merges powerful performance with comfort and versatility, making it a valuable investment for homeowners. Its numerous features, combined with ease of use, ensure that maintaining a beautiful lawn is not just a chore but a rewarding experience.
Top Page Image Contents