Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. Review the video cassette before you begin.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard wrench sizes you need
are | listed | below. |
|
|
(1) | 9/16" | wrench | (1) | Pliers |
(1) | 1/2"wrench | (1) | Utility knife | |
(1)3/4" socket with drive ratchet
(1)Tire pressure gauge
When right or left hand is mentioned in this manual, it means, from your point of view, when you are in the operating position (seated behind the steering wheel).
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
1.Remove all accessible loose parts and parts boxes from carton.
2.Cut along dotted lines on all four pan- els of carton. Remove end panels and lay side panels flat.
3.Remove mower and packing materials.
4.Check for any additional loose parts or cartons and remove.
BEFORE REMOVING TRACTOR FROM SKID
ATTACH STEERING WHEEL
1.Remove hex bolt, lock washer and large flat washer from steering shaft.
2.Position front wheels of the tractor so they are pointing straight forward.
3.Slide the steering sleeve over the steering shaft.
4.Align tabs and press steering sleeve
extension into bottom of steering wheel.
5.Position steering wheel so cross bars
are horizontal (left to right) and slide onto steering wheel adapter.
6.Secure steering wheel to steering shaft with hex bolt, lock washer and large flat washer previously removed. Tighten securely.
7.Snap steering wheel insert into center of steering wheel.
8.Remove protective materials from trac- tor hood and grill.
| Wheel Insert | |
_1 | ||
| 'l_- | Hex Bolt |
|
| Lock Washer |
Steering | _ | .Large. Flat |
| washer | |
Adap 's'Whe°'erl;
Steering | _ | , |
Sleeve | _::::===Tabs |
|
Extension | ! | |
Steering Shaft _ /_'_;x_,
Stee.no : _ !","ii
Sleeve | _.,- | ,:, /' ,_ |
IMPORTANT: Check for and remove any staples in skid that may puncture tires where tractor is to roll off skid.
HOW TO SET UP YOUR TRACTOR
CHECK BATTERY
1.Lift hood to raised position,
NOTE: If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at
Label
8