Craftsman 917.27603 manual To Replace Fuse, To Remove Hood and Grill AS- Sembly, Engine

Terminal,--:'		._	_;i_;_>_l_"	Hex
Access	:: _		_	Bolt
Door ,---_"_ ['4_#;Ag			_w'lr(_ Positive
			(Fled) Cable
Terminal	_	I P
Guard		_	_ _'Negative (Black)
		_,_'J P"	Cable

TO REPLACE HEADLIGHT BULB

1.Raise hood.

2.Pull bulb holder out of the hole in the backside of the grill.

3.Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

4.Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause

your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section,

TO REPLACE FUSE

Replace with 30 amp automotive-type

plug-in fuse, The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL AS- SEMBLY

1.Raise hood.

2.Unsnap headlight wire connector.

3.Stand in front of tractor. Grasp hood at

sides, tilt toward engine and lift off of tractor.

4, When replacing hood, be sure to re* connect the headlight wire connector.

ENGINE

Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the customers ex-

pense, may be performed by any non-road engine repair establishment or individual. Warranty repairs must be performed by an

authorized engine manufacturer's service outlet,

TO ADJUSTTHROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be nec- essary. Check adjustment as described below before loosening cable. If adjust- ment is necessary, proceed as follows:

1.With engine not running, move throttle control lever to fast position.

2.Check that speed control lever is against stop screw. If it is not, loosen casing clamp screw and pull throttle cable until lever is against screw. Tighten clamp screw securely.

Idle Fuel Adjusting	Idle speed Adjusting
Needle

Throttle

Control

Cable

Choke

Control

Cable

Sto_

Scre_;lam! c

28