CLEANING
•Clean engine, battery, seat, finish, etc. of all foreign matter.
•Keep finished surfaces and wheels free of all gasoline, oil, etc.
•Protect painted surfaces with auto- motive type wax.
We do not recommend using a garden hose or pressure washer to clean your tractor unless the engine and transmis- sion are covered to keep water out.
Water in engine or transmission will shorten the useful life of your tractor. Use compressed air or a leaf blower to
remove grass, leaves and trash from tractor and mower.
WARNING:SERVICE ORTOADJUSTMENTS:AVOID SERIOUS INJURY, BEFORE PERFORMING ANY
1.Depress clutch/brake pedal fully and set parking brake.
2.Place gearshift lever in neutral (N) position.
3.Place attachment clutch in "DISENGAGED" position.
4.Turn ignition key to "STOP" and remove key.
5.Make sure the blades and all moving parts have completely stopped.
6.Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.
TRACTOR
TO REMOVE MOWER
Mower will be easier to remove from the right side of tractor.
1.Place attachment clutch in "DISEN- GAGED" position.
2.Move attachment lift lever forward to lower mower to its lowest position.
3.Roll belt off engine pulley.
4.Remove small retainer spring, and remove clutch spring off pulley bolt.
5.Remove large retainer spring, slide collar off and push housing guide out of bracket.
6.Disconnect
7.Disconnect suspension arms from rear deck brackets by removing retainer springs.
8.Disconnect front links from deck by removing retainer springs.
9.Raise lift lever to raise suspension
arms. Slide mower out from under trac- tor.
Small Retainer S
Clutch Spring
Flat Washe_
Housing
IMPORTANT: If an attachment other than the mower deck is to be mounted on the tractor, remove the front links and hook the clutch spring Into square hole in frame.
TO INSTALL MOWER
1.Raise attachment lift lever to its highest position.
2.Slide mower under tractor with deflec- tor shield to right side of tractor.
3.Lower lift lever to its lowest position.
4.Connect front links to mower deck and secure with retainer springs.
5.Connect suspension arms to rear deck brackets and secure with retainer
springs.
6.Connect
7.Push clutch cable housing guide into bracket, slide collar onto guide and secure with large retainer spring.
8.Place flat washer and clutch spring on idler pulley bolt and secure with small retainer spring.
9.Install belt onto engine pulley.
Square Hole | ||
Arms |
|
|
| Engine | Pulley |
| Front | Link |
| Springs | |
(Both | Sides) | |
Deflector Shield
Large Retainer Spring Bracket