INSTALLATION
Hearth Pan Installation (Cont.)
7
INSTALLATION
Continued
4.Using a wrench, remove gas control valve and burner inlet fitting by turning counterclockwise (see Figure 8).
5.Remove the burner inlet fitting from the gas control assembly (see Figure 8). DO NOT remove the orifice from this fitting. The propane/LP burner inlet fitting is included in the hard- ware kit (see Figure 9).
6.Be sure to use the correct orifice for your appliance. The ori- fice kit included with this appliance contains an orifice installed in an air mixer fitting.
7.Using thread sealant (resistant to the action of propane/LP gas) on smaller end of fitting, screw the burner inlet fitting into the outlet side of the gas control (see Figure 8). Tighten using a wrench.
8.Thread gas control valve and burner inlet fitting into burner manifold (see Figure 8). Use thread sealant on male threads of burner inlet fitting. Secure with a wrench. Make sure control rod is facing the front (see Figure 8).
| Screw |
| Thermocouple |
|
|
| Pilot |
Control |
|
|
|
Knob | Valve Cover | Ignitor | |
| |||
Control Rod | Piezo Ignitor |
|
|
|
|
| |
Extension |
|
|
|
Figure 7 - Removing/Installing Cover, Control Knob, and | |||
Piezo Ignitor |
|
|
|
| Burner Inlet |
| |
| Fitting for |
|
|
| Natural Gas |
| |
|
|
| Control |
|
|
| Valve |
| Control Rod | ||
Figure 8- Remove Burner Inlet Fitting |
|
| |
Injector for |
|
| Injector for |
Natural Gas |
|
| Propane/LP |
|
|
| Gas |
NATURAL |
| PROPANE/LP | |
GAS FITTING |
| GAS FITTING |
9.To adjust regulator pressure, remove the brass hex plug from regulator (see Figure 10).
10.Remove the plastic pressure button from the brass plug (see Figure 10).
11.Reverse the plastic pressure button and replace it into the brass plug (see Figure 10).
12.Replace brass plug into regulator.
13.Using two screws removed in step 2, page 6, replace valve cover.
14.Gently loosen and remove the pilot line connection from the pilot bracket (see Figure 11).
15.Replace injector with propane/LP injector with red stripe.
16.Replace and tighten pilot line to bracket.
17.Using screws removed in step 2, page 6, reattach pilot bracket to valve cover.
18.Continue with step 1 under Hearth Pan Installation, page 6.
Regulator | Reversed Plastic |
| |
| Pressure Button |
| for Propane/LP |
| Conversion |
| Brass Plug |
Plastic Pressure Button Positioned for Natural Gas
Figure 10 - Adjusting Regulator Pressure for Conversion
Pilot Bracket
Pilot Injector
Pilot Adjustment Screw
Figure 11 - Installing Propane/LP Pilot Orifice
Figure 9 - Burner Inlet Fittings with Injectors
For more information, visit www.desatech.com
901268