A WARNING: To avoid serious injury, before performing any service and adjustments:
1.Release control bar and stop engine.
2.Make sure the blade and all moving parts have completely stopped.
3.Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.
LAWN MOWER
TO ADJUST CUTTING HEIGHT
See "TO ADJUST CUTTING HEIGHT" in the Operation section of this manual.
NOTE: Always use factory approved belt to assure proper fit and long life.
Blade adapter | Key | Crankshaft |
|
| <eyway |
Lockwasher |
|
|
REAR DEFLECTOR
The rear deflector, attached between the rear wheels of your mower, is provided to minimize the possibility that objects will be thrown out of the rear of the mower into the operator mowing position. If the deflector becomes damaged, it should be replaced.
TO REMOVE DRIVE BELT
1.Remove drive cover and belt keeper.
2.Remove belt from gearcase pulley.
3.Turn lawn mower on its side with air filter and carburetor down.
4.Remove blade and blade adapter.
5.Remove belt from engine pulley.
Drive cover
\
Gearcase pulley
Belt 3er
J Belt
TO REPLACE DRIVE BELT
1.Place new drive belt on engine pulley, inside tabs of belt retainer.
2.Route the other end of the new drive belt through hole in housing.
3.Reinstall blade adapter and blade.
4.Return mower to upright position.
5.Install new belt on gearcase pulley.
6.Reinstall belt keeper and drive cover.
Blade
Blade | Hardened |
|
|
bolt | \, |
| |
| washer | 'Trailing/edge | retainer |
TO ADJUST HANDLE
The handle on your lawn mower has three
(3)height positions - adjust to height that suits you.
1.Remove knob and carriage bolt on one side of the lower handle.
2.While holding handle assembly, remove knob and carriage bolt from
opposite side, align hole in handle with desired hole in handle bracket and
reassemble bolt and knob and tighten securely.
3.Align opposite side of handle with
same positioning hole and secure with bolt and knob.
Handle bracket
Knob
Bolt
16