Craftsman 917.28955 To Check Brake, Front Wheel TOE-IN/CAMBER, To Remove Wheel for Repairs

Page 27

TO CHECK BRAKE

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a

level, dry concrete or paved surface, then brake must be serviced.

You may also check brake by:

1.Parktractoronalevel,dryconcreteorpaved

surface, depress clutch/brake pedal all the way down and engage parking brake.

2.Place gear shift lever in neutral position. The rear wheels must lock and skid when

you try to manually push the tractor forward. If the rear wheels rotate, then the brake needs to be serviced. Contact a Sears or other qualified service center.

FRONT WHEEL TOE-IN/CAMBER

Your new tractor front wheel toe-in and cam- ber is set at the factory and is normal. The front wheel toe-in and camber are not adjust- able. If damage has occurred to affect the factory set front wheel toe-in or camber, con- tact a Sears or other qualified service center.

TO REMOVE WHEEL FOR REPAIRS

1.Block up axle securely.

2.Remove axle cover, retaining ring and washers to allow wheel removal (rear wheels have a square key - Do not lose).

3.Repair tire and reassemble.

NOTE: On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

4.Replace washers and snap retaining ring securely in axle groove.

5.Replace axle cover.

NOTE: To seal tire punctures and prevent

flat tires due to slow leaks, purchase and use tire sealant from Sears. Tire sealant also

prevents tire dry rot and corrosion.

Washers

Retaining

Ring

TO START ENGINE WITH A WEAK BAT- TERY

_kWARNING: Lead-acid batteries gener-

ate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the

MAINTENANCE section of this manual).

If "jumper cables" are used for emergency starting, follow this procedure:

IMPORTANT: Your tractor is equipped with a 12 volt system. The other vehicle must also be a 12 volt system. Do not use your tractor battery to start other vehicles.

TO ATTACH JUMPER CABLES

1.Connect one endofthe RED cable to the POSITIVE (+) terminal of each battery(A- B), taking care not to short against tractor chassis.

2.Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

3.Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER

1.BLACK cable first from chassis and then from the fully charged battery.

2.RED cable last from both batteries.

Weak or Dead Fully Charged

BatteryBattery

I

Axle Cover

_---,Square Key (Rear

Wheel Only)

27

Page 26 Page 28
Image 27
Page 26 Page 28
Contents SEARS, Roebuckand CO., Hoffman ESTATES, IL 60179 U.S.A CRI FtsmrnDays on Battery Craftsman Limited Warranty TWO Years on TractorGeneral Operation Service IV. TowingSafe Handling of Gasoline GENERALSERVlCE Repair Protection Product SpecificationsSears Installation Service Customer Responsibilities1/40.D. Washer Mower Front WheelAssemble Front Wheel to Mower To Remove Tractor fromCarton Before Removing TractorINSTALL Mower and Drive Belt Ing bracket Disengage Belt tension rod K from lockCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position@@@ Attachment Clutch Switch Service Reminder / Hour MeterKnow Your Tractor To SET Parking Brake HOW to USE Your TractorStopping Mower Blades EngineTo Move Forward and Backward To Adjust Mower Cutting HeightTo Adjust Gauge Wheels To Operate MowerCheck Engine OIL Level Before Starting the EngineTo Transport Towing Carts and Other ATTACH= MentsTo Start Engine ADD GasolineReserve Fuel Valve Operation Mowing Tips Schedule ChartGeneral Recommendations Before Each USECheck Operator Presence System Check Reverse Operation ROS SystemTires Lubrication To Clean Battery and TerminalsTransaxle Cooling EngineMuffler To Service CartridgeClean AIR Screen IN=LINE Fuel FilterCution Deck Washout PortTo Remove Mower To Install MowerTo Level Mower Visual SIDE-TO-SIDE AdjustmentFRONT-TO-BACK Adjustment Precision SIDE-TO-SIDE AdjustmentTo Replace Motion Drive Belt Mower Drive Belt InstallationBelt Installation Mower Drive Belt RemovalTo Start Engine with a Weak BAT- Tery To Check BrakeFront Wheel TOE-IN/CAMBER To Remove Wheel for RepairsTo Remove Hood & Grill Assembly Other BatteryTractor EngineProblem Cause Will not startCorrection Loss of power ProblemcauseDischarge Headlights not working If so equipped CuttingTractor Is shifted Battery Will NotWhen Turning Engine BackfiresINE Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationGARANTiA Limitada DE Craftsman DOS AltOS Para Tractores Advertenoia Funoionamiento GeneralGasolina III. NII OSManipulacion Segura DE LA IV. RemolquePage API-SG-SL LA REPARAClONEspecificaciones DEL ProductoDe uni6n Deantera Rear Lift Link BarraAntioscilaci6n Montaje de la piezaPara Para Hacer Rodar EL TractorFuera DE LA Corredera Vea la sec= LA CorrederaFije LA Pieza DE Union Anterior E Instale LA Segadora Y LA Correa DE TRANSMISI6NTaje DE LA Segadora Y DE LA Correa DE Transmision Instale Primero LA Barra Anti Balanceo SPage Jlista DE Revision Revision DE LA Presion DE LAS LlantasRevision DE LA Nivelacion DEL Conjunto Revision DEL Sistema DE Frenos@@@@ Istema DE Funcionamjento Hacia Familiaricese CON SU TractorMiento Como Usar SU TractorLA Segadora Para Transportar Funcionamiento AtrasUsar EL Sistema DE Funcionamiento ATR,,S Para Operar EN CerrosArranque CON Tiempotem Plado 50/10 Y MAS Agregue GasolinaPara Operar DE LA Valvula DE Gasolina DE Reserva Para Hacer Arrancar EL MotorConsejos Para Segar DE Lubricacion Recomendaciones GeneralesAntes DE Cada USO TablaTractor Motor Lubricacksn 4rmiMmpieza DE LA Entrada DE AIRE/AREAS DE Enfriamento LimpiezaFiltro DE Combustible EN Linea Limpieza DE LA Rejilla DE AireImportante Puerto DE Lavado DE LA CubiertaInstalar LA Segadora Y LA Correa DE Para Desmontar LA Cortadora DECesped Para Instalar LA SegadoraRegulacion DE LA Precision DE Lado Para Nivelar LA SegadoraRegulacion Visual DE Lado a Lado Ajuste DE Delante a ATR,SMontaje DE LA Correa DE LA SEGA- Dora Controlar Y Ajustar EL FrenoControl DEL Freno Impresion / Inclinacion DE LAS Ruedas Delanteras Para Cameiar LA Correa DE Impulsion DE MovimientoDesmontaje DE LA Correa Montaje DE LA CorreaEntrecierre Y Reles Para ADJ U Ntar LOS CAB LES DE EM Palm EReemplazar LA Bateria Para Cambiar LA Bombilla DE LA LUZ DelanteraCarburador MotorCilindros OtrosMotor Sistema DE Combustible Aceite DEL MotorEstrangulacion Choke ProblemaCausa CorreccionProblema Identificacion DE ProblemasLas luz ces delanteras no est.n Operacion Segura Solamente Ande Cuesta Arriba OCuesta Abajo Y no Atraviese EL Cerro 15GRADOS MAX Your Home Needmore

917.28955 specifications

The Craftsman 917.28955 is a noteworthy addition to the realm of lawn care equipment, specifically designed for homeowners seeking reliability and efficiency in their mowing tasks. This riding mower combines power, comfort, and innovative technology, making it ideal for those with medium to large lawns.

One of the standout features of the Craftsman 917.28955 is its robust engine. Powered by a 17.5 horsepower Briggs & Stratton engine, this mower ensures ample power for cutting through various types of grass, including thick or wet conditions. The engine's performance is complemented by an automatic transmission, allowing the operator to experience smooth shifting without the hassle of manual adjustments. This feature significantly enhances maneuverability and overall mowing ease.

The design of the mower is user-friendly, with a 42-inch cutting deck that strikes a perfect balance between efficiency and ease of use. This size allows for quicker mowing of larger areas while still enabling access to tighter spots, making it versatile for various lawn layouts. The cutting height can be easily adjusted to six different positions, allowing users to customize their mowing height according to the season or grass type.

Another innovative aspect of the Craftsman 917.28955 is its integrated technology. The mower is equipped with a deck wash system, which simplifies maintenance by allowing users to connect a water hose to the mower's deck for convenient cleaning. Keeping the mower's deck clean ensures optimal performance and longevity.

Comfort is not overlooked in the design of the Craftsman 917.28955. The tractor-style seat is designed to provide a comfortable ride, featuring an ergonomic shape and ample padding. The easy-to-reach controls empower the operator to adjust speeds, cutting heights, and other functions effortlessly, enhancing the mowing experience.

Furthermore, the Craftsman 917.28955 emphasizes safety with features such as the operator presence control, which ensures the mower only operates when the operator is seated. This crucial safety feature helps prevent accidents by automatically shutting off the blades if the operator dismounts the seat.

In summary, the Craftsman 917.28955 is an exceptional riding mower that effectively combines power, user-friendly features, and innovative technology. With its reliable engine, adjustable cutting deck, integrated maintenance systems, and focus on comfort and safety, this mower is poised to meet the diverse needs of modern homeowners looking to maintain their lawns efficiently and effortlessly.
Top Page Image Contents