Craftsman 917.374365 Grass Catcher, Gear Case, Engine Lubrication, To Change Engine OIL

Page 15

GRASS CATCHER

•The grass catcher may be hosed with water, but must be dry when used.

•Check your grass catcher often for dam- age or deterioration. Through normal use it will wear. If catcher needs replac- ing, replace only with approved replace- ment catcher shown in the Repair Parts section of this manual. Give the lawn mower model number when ordering.

GEAR CASE

•To keep your drive system working properly, the gear case and area around the drive should be kept clean and free

of trash build-up. Clean under the drive cover twice a season.

•The gear case is filled with lubricant to

the proper level at the factory. The only time the lubricant needs attention is if

service has been performed on the gear case.

•If lubricant is required, use only Texaco Starplex Premium 1 Grease, Part No. 750369. Do not substitute.

ENGINE LUBRICATION

Use only high quality detergent oil rated with API service classification SG-SL. Select the

oil'sSAE viscosity grade according to your expected operating temperature.

SAE VISCOSITY GRADES

F

-20

 

0

30

32

40

 

60

80

100

C

-30

-20

-10

 

0

 

110

20

30

40

TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE

NOTE: Although multi-viscosity oils (5W30, 10W30 etc.)improve starting in cold weather, these multi-viscosity oils will result in increased oil consumption when used above 32°F. Check your engine oil level more frequently to avoid possible engine damage from running low on oil. Change the oil after every 25 hours of op- eration orat least once a year if the mower is not used for 25 hours in one year. Check the crankcase oil level before starting the engine and after each five (5) hours of continuous use. Tighten oil plug

securely each time you check the oil level.

TO CHANGE ENGINE OIL

NOTE: Before tipping lawn mower to drain oil, empty fuel tank by running engine until fuel tank is empty.

1.Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

. Remove engine oil cap; lay aside on a clean surface.

3.Tip lawn mower on its side as shown and drain oil into a suitable container. Rock lawn mower back and forth to re-

move any oil trapped inside of engine.

Container

4.Wipe off any spilled oil from lawn mower or side of engine.

5.Slowly pour oil down the oil fill spout, stopping every few ounces to check the oil level with the dipstick.

6.Stop adding oil when you reach the FULL mark on the dipstick. Wait a minute to allow oil to settle.

7.Continue adding small amounts of oil, rechecking the dipstick until oil level settles at FULL. DO NOT overfill, or engine will smoke heavily from the muffler on startup.

8.Always be sure to retighten oil dipstick before starting engine.

9.Reconnect spark plug wire to spark plug.

AIR FILTER

Your engine will not run properly and may be damaged by using a dirty air filter. Replace the air filter cartridge every 100

hours of operation or every season, which- ever occurs first. Service air cleaner more

often under dusty conditions.

TO CLEAN AIR FILTER

1.Loosen screw and tilt cover to remove.

2.Carefully remove cartridge.

3.Clean by gently tapping on a flat sur-

face. If very dirty, replace cartridge.

,_CAUTION: Petroleum solvents, such as kerosene, are not to be used to clean cartridge. They may cause deterioration of the cartridge. Do not oil cartridge. Do not use pressurized air to clean or dry cartridge.

4.Install cartridge, then replace cover making sure the tabs are aligned with the slots in the back plate. Fasten screw securely.

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Craftsman Your Safety is Involved Yearfull Warranty on Craftsman Lawn MowerGeneral Operation IV. Safe Handling of GasolineDo not RJ19HX General ServiceLawn Mower Performance Lawn Mower MaintenancePosition To Remove Mower from CartonTo Unfold Handle MowingTo Prepare Battery To Install AttachmentsTo Assemble Grass Catcher Know Your Lawn Mower Meets Cpsc Safety RequirementsEngine Speed To Convert Mower Rear BaggingSide Discharging For Rear BaggingBefore Starting Engine Mowing Tips Mulching Mowing TipsBefore After Every General RecommendationsBefore Each USE LubricationDrive Wheels Lawn MowerEngine Lubrication To Clean AIR FilterGrass Catcher Gear CaseMuffler CleaningClean Under Drive Cover Water Washout FeatureTo Replace Drive Belt To Adjust HandleRear Deflector To Remove Drive BeltFold Forward for Storage Mowing Position CarburetorHandle Engine SpeedFuel System BatteryProblem Cause Correction OtherCause ProblemSU Seguridad Esta Comprometida Sears, Roebuck and Co., Hoffman Estates, ILHacer OperacionIII. Ninos II. Operacion Sobre LAS CuestasRJ19HX SAEMantenimiento DE LA Segadora Rendimiento DE LA SegadoraPara Remover LA Segadora DE LA Caja DE Carton Como Preparar SU SegadoraPara Instalar LOS Accesorios Para Montar EL Recogedor DEProducto. Aprenda y comprenda sus significados Familiaricese CON SU SegadoraATRA.SPARA Bajar Palancahacia EL CORTAC¢SPED Como Usar SU SegadoraControl DE LA IMPULSI6N Ajuste DEL MandoPara Ensacamiento Trasero Para Convertir LA SegadoraSegadoras CON Descarga Trasera Segadoras CON Descarga LateralPara Parar EL Motor Antes DE Hacer Arrancar EL MotorConsejos Para Segar Y ACOL- Char Onsejos Para SegarAntes DE Cada USO Recomendaciones GeneralesCuidado DE LA Cuchilla SegadoraLlantas Ruedas DE IMPULSI6NFiltro DE Aire Recogedor DE CospedCaja DE Engranajes Para Cambiar EL Aceite DEL MotorLimpieza Derrubio DEL AguaLimpie Debajo DE LA Cubierta DE LA Impulsion Para Remover Correa DE Impulsion SegadoraLA Altura DE Corte Desviador TraseroCarburador Velocidad DEL MotorCilindro Problema CausaMotor Aceite DEL MotorCorreccion CausaCraftsman Rotary Lawn Mower - Model Number Craftsman KEY Part DescriptionSAE 30W 419 KEY Craftsman Rotary Lawn Mower - Model Number 917o374365Briggs & Stratton 4-CYCLE Engine Model Number 128T05-1268=B1 564 883 KEY Part Briggs & Stratton Cycle EngineBriggs & STRATTON4-CYCLE Engine Service Notes Service Notes Serifs
Top Page Image Contents