TROUBLESHOOTmNG CHART:
See appropriate section in rnanuam urfless directed to Sears service center
PROBLEM | CAUSE |
|
| CORRECTmON |
| |||
Mower blades wiii | 1. | Obstruction | in clutch | 1. | Remove | obstruction. | ||
not rotate |
| mechanism. |
|
|
|
|
| |
| 2. | Worn/damaged | mower drive | 2. | Replace | mower | drive belt. | |
|
| belt. |
|
|
|
|
|
|
| 3. | Frozen | idler | pulley. | 3. | Replace | idler pulley. | |
| 4. | Frozen | blade | mandrel. | 4. | Contact | a Sears | or other |
|
|
|
|
|
| qualified | service | center. |
Poor grass1. Engine speed too slow. discharge
2.Travel speed too fast.
3.Wet grass.
4.Mower deck not level.
5.Low/uneven tire air pressure
6.Worn, bent or loose blade.
7.Buildup of grass, leaves and trash under mower.
8.Mower drive belt worn.
9.Blades improperly installed.
10.Improper blades used.
11.Clogged mower deck vent holes from buildup of grass, leaves, and trash around mandrels.
1.Place throttle control in "FAST" position.
2.Shift to slower speed.
3.Allow grass to dry before mowing.
4.Level mower deck.
5.Check tires for proper air pressure.
6.Replace/sharpen blade. Tighten blade bolt.
7.Clean underside of mower housing.
8.Replace mower drive belt.
9.Reinstall blades sharp edge down.
10.Replace with blades listed in this manual.
11.Clean around mandrels to open vent holes.
Headlight(s) not working
(if so equipped)
Battery wiii not charge
Engine "backfires" when turning engine "OFF"
1.Switch is "OFF".
2.Bulb(s) or lamp(s) burned out.
3.Faulty light switch.
4.Loose or damaged wiring.
5.Blown fuse.
1.Bad battery cell(s).
2.Poor cable connections.
3.Faulty regulator (if so equipped).
4.Faulty alternator.
. Engine throttle control not set at "SLOW" position for 30 seconds before stopping engine.
1.Turn switch "ON".
2.Replace bulb(s) or lamp(s).
3.Check/replace light switch.
4.Check wiring and connections.
5.Replace fuse.
1.Replace battery.
2.Check/clean all connections.
3.Replace regulator.
4.Replace alternator.
. Move throttle control to
"SLOW" position and allow to idle for 30 seconds before
stopping engine.
30