Craftsman 917.27105 manual To Replace Headlight Bulb, Interlocks and Relays, To Replace Fuse

Page 24

Positive Terminal

Negative Terminal

_les

ged

Battery

Positive Terminal	Negative Terminal

REPLACING BATTERY

CAUTION: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch

bands,rings,etc.

Positive terminal must be connected first to prevent sparking from accidental grounding.

•Lift seat pan to raised position and open battery box door.

•Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•First connect RED battery cable to positive (+) terminal with hex bolt and nut as shown. Tighten securely.

•Connect BLACK grounding cable to negative (-) terminal with remaining hex bolt and nut. Tighten securely.

•Close battery box door.

Sea

Battery

Door

Box

Hex

NutBolt

lRed) Cable Negative (Black) Cable

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 15 amp automotive-type

plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOODAND GRILL ASSEMBLY

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

24

Image 24

Contents Rrftsmrn Limitedtwo Year Warrantyon Craftsmanriding Equipmentparts General Operation Do notChildren Service Machine. Taft grass can hide obsta- clesProduct Specifications Keys Video Cassette Slope Sheet Tools Required for Assembly HOW to SET UP Your TractorTo Remove Tractor from Carton Before Rolling Tractor OFF SkidInstall Seat To Drive Tractor OFF SkidTo Convert to Bagging or Discharging Check Tire PressureCheck Brake System Check Deck LevelnessForward Knowyour Tractor HOW to USE Your Tractor To USE THROI-FLE ControlTo Operate Mower To Operate on HillsTo Transport Before Starting the Engine Check Engine OIL LevelTo Start Engine AddgasolineMowing Tips Mulching Mowing TipsLubrication Chart General RecommendationsBefore Each USE Tractor Engine Transaxle CoolingClean AIR INTAKE/COOLING Areas MufflerAIR Filter Spark PlugsCleaning To Install MowerTo Remove Mower To Level Mower Housing SIDE-TO-SIDE AdjustmentTo Adjust Brake To Replace Motion Drive BeltNeutraladjustment To Adjust Steering Wheel AlignmentTransaxle Gear Shift Lever Front Wheel TOE-IN/CAMBERReplacing Battery To Remove Hoodand Grill AssemblyTo Replace Headlight Bulb Interlocks and RelaysTo Adjust Throttle Control Cable To Adjust CarburetorAcceleration Test Battery EngineChart Problem CauseCorrection Problem CauseTroubleshooting Chart Problemcause DischargeTractor - Model Number Schematic LJltTractor - Model Number Electrical Tractor --MODEL Number ElectricalTractor - Model Number Chassis and Enclosures 208KEY Part Description Tractor - Model Number Ground Drive 116 169 1702 261Dimensions given in U. S Transaxle See BreakdownBolt, Hex 7/16-20 206-545CTractor - Model Number 917.271050 Steering Assembly KEY Part NO. no Tractor - Model Number Optional EquipmentEngine KEY Part NO. NO.DESCRIPTION 16 STD551231 Washer79 M740108025 Bolt Hex Tractor - Model Number Seat Assembly 140122121248X Bushing Snap BIk Nyl 50 Id 140551 145OO6Tractor - Model Number DecalsWheels & Tires Tractor - Model Number Lift Assembly 159460 Washer 159471Inch = 25.4 mm TRACTOR-- Model Number Mower Deck 106 , 102119 114 115 117 Mower Deck Assembly 144959 Belt Bolt Hardened 130794 Mandrel Assembly Includes165892 STD624008150 70 BA Part Description Spacer+ Ittt .,o-i I..-./1 Fuel System J Cylinder HEAD, Valve and Breather Crankcase Starting System Blower Housing and Baffles KEY Part NO. NO.DESCRIPTION AIR Intake KEY Part NO. NO.DESCRIPTIONNotillustrated Crankshaft KEY Part NO. NO.DESCRIPTIONFuel System KEY Part NO. no Cylinder HEAD, Valve and BreatherDescription KEY Part 41-518-34Ignition / Electrical KEY Part NO. NO.DESCRIPTION OIL PAN / Lubrication KEY Part DescriptionCrankcase KEY Part NO. no Page Page Page Only Ride UP and Down Hill Not Across HillSighting GuidePart 6 a.m.- 11 p.m. CST SearsPara pedir servicio de reparaci6n a domicilio Sears, Roebuck and Co