TROUBLESHOOTING |
| CHART |
|
|
|
|
| |||
PROBLEM |
| CAUSE |
|
|
|
|
|
| ||
Engine | clicks but | • | Weak | or dead | battery. | |||||
will not | start | • | Corroded | battery | terminals. | |||||
|
| • | Loose | or damaged | wiring. | |||||
|
| • | Faulty | solenoid | or starter. | |||||
Loss of power | • | Cutting | too | much | grass/too | |||||
|
|
| fast. |
|
|
|
|
|
|
|
|
| • | Throttle | in"CHOKE" |
| |||||
|
|
| position. |
|
|
|
|
| ||
|
| • | of | grass, | leaves | |||||
|
|
| and | trash | under | mower. | ||||
|
| • | Dirty | air filter. |
|
|
| |||
|
| • | Low | oil level/dirty | oil. | |||||
|
| • | Faulty | spark plug. |
| |||||
|
| • | Dirty fuel filter. |
|
|
| ||||
|
| • | Stale | or dirty fuel. |
| |||||
|
| • | Water | in fuel. |
|
|
| |||
|
| • | Spark | plug | wire | loose. | ||||
|
| • | Dirty | engine | air screen/fins. | |||||
|
| • | Dirty/clogged | muffler. | ||||||
|
| • | Loose | or damaged | wiring. | |||||
|
| • | Carburetor | out of |
| |||||
|
|
| adjustment. |
|
|
|
| |||
|
| • | Engine valves | out of | ||||||
|
|
| adjustment, |
|
|
|
| |||
Excessive |
| Worn, | bent | or | loose blade. | |||||
vibration |
|
|
|
|
|
|
|
|
| |
|
|
| Bent | blade | mandrel. | |||||
|
|
| Loose/damaged |
| part(s). | |||||
Enginecontinues | • | Faulty | ||||||||
to run |
|
| presence | control system. | ||||||
when operator |
| |||||||||
|
|
|
|
|
|
|
|
| ||
leaves | seat |
|
|
|
|
|
|
|
|
|
with attachment |
|
|
|
|
|
|
|
|
| |
clutch | engaged |
|
|
|
|
|
|
|
|
|
ICORRECTION
•Recharge or replace battery.
•Clean battery terminals.
•Check all wiring.
•Check/replace solenoid or starter.
•Set in "Higher Cut" position/ reduce speed.
•Adjust throttle control.
•Clean underside of mower housing.
•Clean/replace air filter.
•Check oil level/change oil.
•Clean and regap or change spark plug.
•Replace fuel filter.
•Drain fuel tank and refill with fresh gasoline.
•Drain fuel tank and carbure tor, refill tank with fresh
gasoline and replace fuel filter.
•Connect and tighten spark plug wire.
•Clean engine air screen/fins.
•Clean/replace muffler.
•Check all wiring.
•See "To Adjust Carburetor" in
Service Adjustments section.
•Contact an authorized service center/department.
•Replace blade.
Tighten blade bolt.
•Replace blade mandrel.
•Tighten loose part(s). Replace damaged parts.
Check wiring, switches and connections. If not
corrected, contact an autho rized service center/
department.
29