Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness.
TOOLS |
| REQUIRED | FOR ASSEMBLY | • Assemble large flat washer, 3/8 lock | ||||||||||||
|
|
|
|
|
|
|
|
|
| |||||||
A socket wrench set will make | assembly |
| washer, 3/8 | hex bolt and tighten | ||||||||||||
easier. | Standard wrench | sizes | you need |
| securely. |
|
|
|
|
| ||||||
are listed | below. |
|
|
|
|
| • | Snap steering | wheel insert | into center | ||||||
(1) 9/16" | wrench | (1) | Pliers |
|
|
| of steedng | wheel. |
|
| ||||||
(2) 1/2" | wrench |
| (1) Utility knife |
| • | Remove | protective | materials from | ||||||||
(1) 3/4" socket | with | (1) Tire pressure |
|
| tractor hood | and grill. |
| |||||||||
drive |
| ratchet |
|
| gauge |
| IMPORTANT: |
| Check | for and remove | ||||||
When right or left hand | is mentioned | in | any staples | in skid that may | puncture | |||||||||||
this manual, | it means, | from your point of | tires where | tractor is to roll off skid. | ||||||||||||
view, when | you are | in the operating |
|
|
|
|
| _ | Steering | |||||||
position (seated behind the steering |
|
|
|
|
| _ | Wheel Insert | |||||||||
wheel). |
|
|
|
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
| Hex Bolt | ||
TO REMOVE | TRACTOR | FROM |
|
|
|
|
|
| ||||||||
|
|
|
| _Lock |
| Washer | ||||||||||
CARTON |
|
|
|
|
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
| f_! |
| Large Flat | ||||
|
|
|
|
|
|
|
|
|
|
|
|
| ||||
UNPACK | CARTON |
|
|
|
|
|
|
|
|
|
|
|
| |||
* Remove | all accessible | loose parts | and |
| Steering j_.._ | _ |
| /_../ |
| |||||||
parts boxes from shipping carton. |
|
| Wheel _ |
|
|
| Boot | |||||||||
|
|
|
|
|
|
| ||||||||||
•Cut, from top to bottom, along lines on all four corners of shipping carton, and lay panels fiat.
•Check for any additional loose parts or boxes and remove.
BEFORE REMOVING TRACTOR
FROM SKID
ATTACH STEERING WHEEL
ASSEMBLE EXTENSION SHAFT AND
BOOT
•Slide extension shaft onto lower
steering shaft. Align mounting holes in extension and lower shafts and
install 5/16 hex bolt and Iocknut. Tighten securely.
•Place tabs of steering boot over tab slots in dash and push down to secure.
INSTALL STEERING WHEEL
•Position front wheels of the tractor so they are pointing straight forward.
•Remove steering wheel adapter from steering wheel and slide adapter onto steering shaft extension.
•Position steering wheel so cross bars are horizontal (left to right) and slide inside boot and onto adapter.
7