Craftsman 917.27076 manual Cleanairscreen

Page 20

Corrosionand dirt on the battery and terminals can cause the battery to "leak" power.

Open battery box door.

Disconnect BLACK battery cable first then RED battery cable and remove battery from tractor.

Rinse the battery with plain water and dry.

Clean terminals and battery cable ends with wire brush until bright.

Coat terminals with grease or petro- leum jelly.

Reinstall battery (See =REPLACING

BATTERY" in the SERVICE AND ADJUSTMENTS section of this

manual).

V-BELTS

Check V-belts for deterioration and wear after 100 hours of operation and replace if necessary. The belts are not adjustable. Re- place belts if they begin to slip from wear.

TRANSAXLE COOLING

The transmission fan and cooling fins should be kept clean to assure proper cooling. Do not attempt to clean fan or transmission while engine is running or while the trans- mission is hot. To prevent possible damage to seals, do not use high pressure water or steam to clean transaxle.

Inspect cooling fan to be sure fan blades are intact and clean.

Inspect cooling fins for dirt, grass clippings and other materials. To prevent damage to seals, do not use compressed air or high

pressure sprayer to clean cooling fins.

TRANSAXLE PUMP FLUID

The transaxle was sealed at the factory and fluid maintenance is not required for the life of the transaxle. Should the transaxle ever

leak or require servicing, contact your near- ast authorized service center/department.

ENGINE

LUBRICATION

Only use high quality detergent oil rated with API service classification SF, SG, or SH. Select the oil'sSAE viscosity grade according to your expected operating temperature.

SAE VISCOSITY GRADES

NOTE: Although multi-viscosity oils (5W30, 10W30 etc.) improve starting in cold weather, these multi-viscosity oils will result in increased oil consumption when used above 32°1:. Check your engine oil level more frequently to avoid possible engine damage from running low on oil.

Change the oil after every 50 hours of operation or at least once a year if the

tractor is not used for 50 hours in one year.

Check the crankcase oil level before starting the engine and after each eight (8) hours of operation. "lighten oil fill cap/

dipstick securely each time you check the oil level.

TO CHANGE ENGINE OIL

Determine temperature range expected before oil change. All oil must meet API service classification SF, SG or SH.

Be sure tractor is on level surface.

Oil will drain more freely when warm.

Catch oil in a suitable container.

Remove oil fill cap/dipstick. Be careful not to allow dirt to enter the engine when changing oil.

Remove drain plug.

After oil has drained completely, replace oil drain plug and tighten securely.

Refill engine with oil through oil fill dipstick tube. Pour slowly. Do not overfill. For approximate capacity see =PRODUCT SPECIFICATIONS" section of this manual.

Use gauge on oil fill cap/dipstick for checking level. Be sure dipstick cap is tightened securely for accurate reading. Keep oil at =FULL" line on dipstick.

Air Screen__

Oil Drain

Oil Fill Cap//l_L_"-_l:_J_l_ " P_g

Dipstsick _=.______

CLEANAIRSCREEN

Air screen must be kept free of dirt and chaff to prevent engine damage from overheating. Clean with a wire brush or compressed air to remove dirt and stubbom dried gum fibers.

TEMPERATURE RANGE ANTICIPATED BEr-O_E NEXT OIL CHANGE

20

Image 20
Contents £RAFTSMAN For answers to your questionsLimited 90 DAY Warranty on Battery General Operation Slope OperationDo not ChildrenService Maintenance Agreement Product SpecificationsKeys Video Cassette Slope Sheet Steering WheelSeat Before Removing Tractor From Skid Attach Steering Wheel HOW to SET UP Your Tractor Check BatteryInstall Seat To Drive Tractor OFF SkidCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemChecklist Learn and understand their meaning Knowyour Tractor Ammeter LeverHOW to USE Your Tractor StoppingTo Adjust Gauge Wheels To Operate MowerTo Operate on Hills To TransportTowing Carts and Other Atiachments AddgasolineTo Start Engine Before Starting the Enigne Check Engine OIL LevelPurge Transmission Mulching Mowing Tips Mowing TipsLubrication Chart Maintenance ScheduleGeneral Recommendations Before Each USEAlways observe safety rules when performing any maintenance TractorBrake Operation BATrERYCleanairscreen Engine OIL Filter MufflerSpark Plugs IN-LINE Fuel FilterCleaning To Install MowerTo Level Mower Housing To Remove MowerTo Level Mower Housing Belt Installation To Adjust BrakeTo Replace Mower Blade Drive Belt Belt RemovalTransaxle Motion Control Lever Neutral Adjustment To Adjust Steering Wheel AlignmentFront Wheel TOE-IN/CAMBER To Remove Wheel for RepairsReplacing BAIrERY To Replace Headlight BulbTo Attach Jumper Cables To Remove CABLES, Reverse OrderEngine To Remove Hood and Grill AssemblyInterlocks and Relays Tractor Loss of power Enginewill not turn overCause CorrectionTroubleshooting Chart RoblemProblem Cause Correction Troubleshooting ChartBattery will not charge Page Schematic Tractor - Model NumberTRACTOR-- Model Number ElectricalTractor --MODEL Number KEY Part DescriptionTractor --MODE L Number Chassis and Enclosures Tractor --MODEL Number Chassis and Enclosures Tractor -- Model Number Ground Drive Tractor --MODEL Number Ground Drive CADTractor -- Model Number Steeringassembly TRACTOR-- Model Number Steering Assembly ScrewTractor -- Mode L Number Engine Optional EquipmentTractor --MODEL Number EngineTractor - Model Number Seat Assembly Wheels & Tires Tractor - Model NU MberDecals Tractor - Model Number Lift Assembly TRACTOR- Model Number Liftassembly Shaft Assembly, LiftTractor - Model Number Mower DeckMower Deck 2029J= oO Tractor - Model Number Hydro Gear Transaxle - Model Number 75x1.750x.62555 fg 276 1851 Flywheel Coved Page Page Suggested Guide for Sighting Slopes for Safe Operation Sears