STEP 3: (SEE FIGURE 4)
•Place plug (D) on a work bench or solid table and push end of bumper down onto plug. Repeat for all four plugs.
STEP 4: (SEE FIGURE 5)
•Attach ]eft mounting bracket to hole shown in ]eft side of tractor frame using a carriage bolt (A) and whizlock nut (C). Align middle hole in bracket with empty hole in tractor frame. Tighten whizlock nut (C) only enough to keep bracket in alignment until step 5. Repeat for right mounting bracket.
BUMPER
PUSH DOWN
WITH EVEN
PRESSURE
WORK BENCH
OR SOLID TABL__
| (GT) FRAME | SHOWN |
| CARRIAGE | LEFT MOUNTING |
BUMPER | STOPS BOLT (A) | BRACKET |
FACE | OUT | WHIZLOCK |
|
| NUT (C) |
|
| AUGNTRESEROLES | ||
| LEFT SIDE VIEW |
| FIGURE 5 | |
STEP 5: (SEE FIGURE 6) | I | HEX BOLT (B) |
| WHIZLOCK_- |
• Fasten bumper to mounting bracket using a hex bolt |
| |||
|
|
| (C) | |
(B), pivot spacer (E), a locking lever and a whizlock |
|
|
| |
|
|
|
| |
nut (C) as shown. The pivot spacer inserts into hole in |
|
|
|
|
bumper. Tighten both nuts on mounting bracket at |
|
| PIVOT |
|
this time. Repeat for other side. |
|
|
| |
|
| SPACER | (E)_ | |
• Assemble plastic grips (F) onto locking levers. |
|
| ||
|
|
|
| |
• Lift up on bumper until pins in locking levers snap into |
|
|
|
|
holes in mounting brackets. |
|
|
|
|
IMPORTANT: You must lower bumper before raising tractor |
|
|
|
|
hood. Pull out on locking levers and push bumper down as |
|
|
|
|
far as it will go. |
|
|
|
|
| LEVER |
|
| |
|
| GRIP | (F) |
|
| FIGURE | 6 | LEFT | SIDE VIEW |
STEP 6: (SEE FIGURE 7)
•Replace the front screws and browning shield you removed in Step 2 as shown.
REPLACE
FRONT SCREWS
REPLACE
BROWNING | SHIELD |
FIGURE 7 | LEFT SIDE VIEW |
4 | Call |
| DO NOT RETURN TO STORE |