STEP 5: (SEE FIGURE 6)
• | Attach left mounting | bracket to | hole | shown in ]eft |
| side of tractor frame | using bolt | (C), | lock washer (F) |
| and flat washer (G). Align middle hole in bracket | |||
| with empty hole in tractor frame and tighten bolt (C) | |||
(GT) FRAME SHOWN
LEFT MOUNTING | FLAT |
BRACKETWASHERBOLT
(G)(C)
ATTACH TO
to hold bracket in place. Repeat for right mounting |
THiS HOLE
LOCK
bracket. |
WASHER
STEP 6: (SEE FIGURES 7 & 8)
•Assemble plastic grips (E) onto locking levers. To attach bumper to tractor:
1.Place flattened ends of bumper onto mounting brackets. Insert pin of locking lever through front hole in bumper and into front hole in mounting bracket to support bumper on mounting bracket.
2.Insert pivot spacers (D) into rear holes in bumper.
,Fasten locking lever and bumper to mounting bracket using a screw (A) or bolt (B), a lock washer (F) and a flat washer (G). Use screw (A) for LT tractors and bolt
(B)for GT tractors. Assemble screw or bolt through pivot spacer in rear hole in bumper and into tractor frame. Tighten. Repeat for other side.
BUMPER STOPS
FACE OUT
LEFT SiDE ViEW
LEFT SIDE VIEW
(F)
ALIGN THESE HOLES FIGURE 6
PIVOT
SPACER
(D)
GRiP (E)
FIGURE 7
FLAT
WASHER(G)
NOTE: If hole in (LT) tractor frame is not threaded, push in while turning screw (A) to create threads in hole.
IMPORTANT: You must lower bumper before raising tractor hood. Pull out on locking levers and push bumper down as far as it will go.
BOLT (B)
LEFT SIDE VIEW | FIGURE 8 |
Catt | 7 |
DO NOT RETURN TO STORE |
|