BELT INSTALLATION -
•Install new belt in reverse order of removal.
•Make sure belt is in all pulley grooves and inside all belt guides.
•Install mower in reverse order of removal instructions.
TO ADJUST BRAKE
Your tractor is equipped with an adjust-
able brake system which is _nounted on the right side of the transaxle.
If tractor requires more than six (6) feet. stopping distance at high speed in highest gear, then brake must be adjusted.
•Depress clutch/Drake pedal and engage parking brake.
•Measure distance between brake
operating arm and nut "A" on brake rod.
•If distance is other than
•Road test tractor for proper stopping distance as stated above. Readjust if necessary. If stopping distance is still greater than six (6) feet in highest gear, further maintenance is neces- sary. Contact your nearest authorized service center/department.
With Parking Brake "Engaged"
Nut =A"
Jam Nut
TO REPLACE MOTION DRIVE BELT
Park the tractor on level surface. Engage parking brake. For assistance, there is a
belt installation guide decal on bottom side of left footrest.
•Remove mower (See "TO REMOVE
MOWER" in this section of this manual.)
•Remove belt from stationary idler and clutching idler.
•Pull belt slack toward rear of tractor, Remove belt upwards from transaxle pulley by deflecting belt keepers.
•Pull belt toward front of tractor and remove downwards from around engine pulley.
•Install new belt by reversing above procedure.
Engine
Clutchingldler j
StaUonary16_ler
Transaxle
Puney___
TRANSAXLE GEAR SHIFTLEVER
NEUTRAL ADJUSTMENT
The transaxle should be in neutral when the gear shift lever is in neutral (N) (lock gate) position. The adjustment is preset at the factory; however, if adjustment is needed, proceed as follows:
•Make sure transaxle is in neutral (N). NOTE: When the tractor rear wheels
move freely, the transaxle is in neutral.
•Loosen adjustment bolt in front of the right rear wheel.
•Position the gear shift lever in the neutral (N) position.
•Tighten adjustment bolt securely. NOTE: If additional clearance is needed
to get to adjustment bolt, move mower deck height to the lowest position.
Gearshift Lever_ Neutral Lock Gate
[
23