•Connect BLACK grounding cable to negative
•Close terminal access doors.
•Close hood.
Terminal | Keps Nut | Hex Bolt |
Access | .... |
|
Ooor. iii}
ENGINE
Maintenance, repair, or replacement of the emission control devices and
systems, which are being done at the customers expense, may be performed by any
be performed by an authorized engine manufacturer'sservice outlet.
TO ADJUST THROTTLE CONTROL
Guard
_4_1_ Positive
(Red)
"t. Cable
Cable
CABLE
The throttle control has been preset at the factory and adjustment should not be necessary. Check adjustment as described below before loosening cable.
TO REPLACE HEADLIGHT BULB
•Raise hood.
•Pull bulb holder out of the hole in the backside of the gdll.
•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.
•Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.
•Check wiring. See electrical wiring diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 15 amp
TO REMOVE HOOD AND GRILL
ASSEMBLY
•Raise hood.
•Unsnap headlight wire connector.
•Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of tractor.
•To replace, reverse above procedure.
Headlight Wire
Connector
If adjustment is necessary, proceed as follows:
•With engine not running, move throttle control lever to fast position.
•Check that swivel is against side of quarter circle. If it is not, loosen cable clamp screw and pull cable back until swivel is against quarter circle.
Tightencable clamp screw securely.
TO ADJUST CHOKE CONTROL
The choke control has been preset at the factory and adjustment should not be necessary. Check adjustment as described below before loosening cable.
If adjustment is necessary, proceed as follows:
•With engine not running, move choke control (located on dash panel) to full choke position.
•Remove air cleaner cover, filter and cartridge plate to expose carburetor choke (see =AIR FILTER" in the
Customer Responsibilities section of this manual).
•Choke should be closed. If it is not, loosen casing clamp screw and move choke cable until choke is completely closed. Tighten casing clamp screw securely.
•Reassemble air cleaner.
Clamp
Quarter
Circle
/
Swivel
25