INSTALLING HANGER BRACKETS
For better clearance, lower the tractor'ssuspension arms using the attachment lift lever.
On Tractors With Foot Rest Brackets (Figure 7)
•Remove the bolt and nut that fasten the L.H. and R.H. foot rest brackets to the frame. See figure 7.
•Attach the L,H. Hanger Bracket (marked "L') to the inside of the tractor frame using two 3/8" x 1" carriage bolts, 3/8" lock washers and 3/8" hex lock nuts. The bolt heads go on the inside of the tractor frame. Repeat for the R.H, side. See figure 7.
| 3/8" LOCK |
|
BOLT REMOVED | WASHER | / |
. FROM THIS HOLE |
| / |
3/8" HEX |
|
! | t | |
SUSPENSION ARM | ||
3/8" x 1" | L.H. HANGER _ | |
CARRIAGE | ||
BRACKET | ||
ROlL T | ||
| ||
FIGURE 7 | LEFT SIDE VIEW |
On Tractors Without Foot Rest Brackets (Figure 8)
•Find the empty hole beneath the foot rest, Attach the LH. Hanger Bracket (marked "L") to the inside of the frame using a 3/8" x 1" carriage bolt (head to inside), a 3/8" lock washer and a 3/8" hex lock nut. See figure 8. Repeat for the R,H. side.
3/8" LOC_
WASHER_3/8HEX
LOCK NUT
I
SUSPENSION ARM
3/8"x1" | L.H. HANGER _ |
CARRIAGE BRACKET"_
BOLT
INSTALLING SHOULDER BOLTS
All Tractors
•Remove the bolt, washer and nut which fasten the sway bar bracket to the L.H. side of the tractor frame. Replace with a shoulder bolt and a 3/8" hex lock nut as shown in figure 9.
SHOULDER BOLT
I | \ |
|
BOLTREMOVED |
| |
FROM THIS HOLE | 3/8"HEX | |
_. | SWAY BAR | L_CKNUT |
\ | ||
| BRACKET |
|
FIGURE 9 |
| LEFT SIDE VIEW |
Assemble a shoulder bolt and 3/8" hex lock nut to the R.H. side of the tractor frame, using the first empty hole to the rear of the R.H. hanger bracket. See figure 10.
Replace the engine pulley keeper on your tractor with the new pulley keeper supplied with the snow blower. Attach the keeper to the frame using the original bolt, washer and nut. See figure 10. NOTE: Some tractors may already be equipped with an identical pulley keeper.
ORIGINAL BOLT,
NUT AND WASHER
FIGURE 8 | LEFT SIDE VIEW | FIGURE 10 | RIGHT SIDE VIEW |