LAWN MOWER
Always observe safety rules when per- forming any maintenance.
TIRES
,Keep tires free of gasoline, oil, or insect control chemicals which can harm rubber.
,Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage.
DRIVE WHEELS
Check front drive wheels each time before you mow to be sure they move freely.
The wheels not turning freely means trash,
grass cuttings, etc. are in the drive wheel area and must be cleaned to free drive wheels.
If necessary to clean the drive wheels, be sure to clean both front wheels.
1.Remove hubcaps, Iocknuts & washers.
2.Remove wheels from wheel adjusters.
3.Remove any trash or grass cuttings from inside the dust cover, pinion and/ or drive wheel gear teeth.
4.Put wheels back in place.
NOTE: If after cleaning, the drive wheels do not turn freely, contact a Sears or other qualified service center.
BLADE CARE
For best results, mower blade must be kept sharp. Replace a bent or damaged blade. A CAUTION" Use only a replacement blade approved by the manufacturer of your mower. Using a blade not approved by the manufacturer of your mower is haz- ardous, could damage your mower and
void your warranty.
TO REMOVE BLADE
1.Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.
2.Turn lawn mower on its side. Make sure air filter and carburetor are up.
3.Use a wood block between blade and mower housing to prevent blade from
turning when removing blade bolt. NOTE: Protect your hands with gloves and/or wrap blade with heavy cloth.
4.Remove blade bolt by turning counter- clockwise.
5.Remove blade and attaching hardware
(bolt, lock washer, hardened washer). NOTE: Remove the blade adapter and check the key inside hub of blade adapter. The key must be in good condition to work properly. Replace adapter if damaged.
TO REPLACE BLADE
1.Position the blade adapter on the en- gine crankshaft. Be sure key in adapter and crankshaft keyway are aligned.
2.Position blade on the blade adapter.
IMPORTANT: To ensure proper assembly, center hole in blade must align with star on blade adapter.
3.Be sure trailing edge of blade (opposite sharp edge) is up toward the engine.
4.Install the blade bolt with the lock washer and hardened washer into
blade adapter and crankshaft.
5.Use block of wood between blade and
lawn mower housing and tighten the blade bolt, turning clockwise.
,The recommended tightening torque is
IMPORTANT: Blade bolt is heat treated. If bolt needs replacing, replace only with
approved bolt shown in the Repair Parts section of this manual.
Blade adapter | Key | Crankshaft | |
Lockwasher |
|
| |
| Blade |
|
|
|
|
| \ |
Blade |
|
|
|
bolt | Hardened |
|
|
| washer | Trailin/edge | retainer |
TO SHARPEN BLADE
NOTE: We do not recommend sharp-
ening blade - but if you do, be sure the blade is balanced. An unbalanced blade
will cause eventual damage to lawn mower or engine.
,The blade can be sharpened with a file or on a grinding wheel. Do not attempt to sharpen while on the mower.
,To check blade balance, you will need
a 5/8" diameter steel bolt, pin, or a cone balancer. (When using a cone balancer,
follow the instructions supplied with it.) NOTE: Do not use a nail for balancing blade. The lobes of the center hole may appear to be centered, but are not.
,Slide blade on to an unthreaded portion of the steel bolt or pin and hold the bolt or pin parallel with the ground. If blade is balanced, it should remain in a horizontal position. If either end of the blade moves downward, sharpen the heavy end until the blade is balanced.
Center hole
5/8" bolt or pin
13Blade