Craftsman 917272261 owner manual To Start Engine, Viscosity, ADD Gasoline, Warm Weather Starting

Page 16

TOWINGCARTSANDOTHERATFACH-ACAUTION:Fillto bottom of gas tank

MENTS

 

filler neck. Do not overfill. Wipe off any

Towonlytheattachmentsthatare

 

spilled oil or fuel. Do not store, spill or use

recommendedbyandcomplywith

 

gasoline near an open flame.

specificationsofthemanufacturerofyour

TO START ENGINE

tractorUsecommonsensewhentowing.

.

When startingthe engine for the first time

Tooheavyofaload,whileonaslope,is

 

 

or if the engine has run out of fuel, it will

dangerousTirescanlosetractionwith.

 

take extra cranking.time to move fuel from

thegroundandcauseyoutolosecontrol

the tank to the engine.

ofyourtractor.

 

1.

Be sure freewheel control is in the

BEFORESTARTINGTHEENGINE

 

 

transmission engaged position.

CHECKENGINEOILLEVEL

 

2,

Sit on seat in operating position,

Theengineyourtractorhasbeen

 

 

depress brake pedal and set parking

 

 

brake.

shipped,fromthefactory,alreadyfilled

 

3.

Move attachment clutch to =DISEN-

withsummerweightoil.

 

 

GAGED" position.

1, Checkengineoilwithtractoronlevel

 

4.

Move throttle control to fast position

5.Pull choke control out for a cold

2.Removeoilfillcap/dipstickandwipe engine start attempt. For a warm clean,reinsertthedipstickandscrew engine start attempt the choke control

captight,waitforafewseconds, may not be needed.

removeandreadoillevel.Ifneces- NOTE: Before starting, read the warm andground.

sery, add oil until "FULL" mark on

cold starting pmceduras below.

 

dipstickis reached. Do not overfill.

6.

Insert key into ignition and turn key

• For cold weather operation you should

 

clockwise to "START" position

end

change oil for easier starting(See "OIL

 

release key as soon as engine starts.

VISCOSITY

CHART" in the Mainte-

 

Do not run starter continuouslyfor

nance section of this manual).

 

more than fifteen seconds per minute.

 

If the engine does not start after

• To change engine oil, see the Mainte-

 

 

several attempts, push choke control

nance section in this manual.

 

 

in, wait a few minutes and try again. If

ADD GASOLINE

 

 

engine still does not start, pullthe

Fill fuel tank. Use fresh, clean, regular

 

choke control out and retry.

,

unleaded gasoline with a minimum of

 

WARM WEATHER STARTING (50

F and

87 octane. (Use of leaded gasoline will

above)

 

 

increase carbon and lead oxide

7. When engine starts, slowly push

deposits and reduce valve life). Do not

 

choke control in until the engine

mix oil with gasoline. Purchase fuel in

 

begins to run smoothly. If the engine

quantities that can be used within 30

 

starts to run roughly, pull the choke

days to assure fuel freshness.

 

control out slightlyfor a few seconds

IMPORTANT: When operating in tem-

 

and then continue to push the control

peratures below 32°F(0°C), use fresh,

 

in slowly.

 

 

clean winter grade gasoline to help

The attachments and ground drive can

insure good cold weather starting.

 

now be used. If the engine does not

•,WARNING:

-Experienceindicates that

 

accept the load, restart the engine and

alcohol blended fuels (called gasohol or

 

allow it to warm up for one minute

using ethanol or methanol) can attract

 

using tho choke as described above.

moisture which leads to separation and

 

COLDWEATHER

STARTING (50

F and

formation of acids during storage. Acidic

below)

 

 

gas can damage the fuel system of an

7.

When engine

starts, slowly push

engine while in storage. To avoid engine

 

choke control in until the engine

problems,the fuel system should be

 

begins to run smoothly. Continue to

emptied before storage of 30 days or

 

push the choke control in small steps

longer. Drain the gas tank start the

 

allowing the engine to accept small

engine and let it ran until the fuel lines

 

 

changes =nspeed and load, until the

and carburetor are empty. Use fresh fuel

 

choke control is fully in. If the engine

next season. See Storage Instructions for

 

starts to run roughly, pullthe choke

additional information. Never use engine

 

control out slightly for a few seconds

or carburetor cleaner products in the fuel

 

and then continue to push the control

tank or permanent damage may occur.

 

in slowly. This may require an engine

 

 

 

warm-up period from several seconds

 

 

 

to several minutes, depending on the

 

16

 

temperature.

 

 

Image 16
Contents Lawn Tractor Sears, Roebuck and Co., /817 WA, Hoffman Estates, IL General Operation I1. Slope Operation Do notIV. Service III. ChildrenHeavy of a load, while on a slope, is Safety is InvolvedCancer and birth defects or other repro- ductive harm Read and observe the safety rules OFILTER3.75PINTSReverse Repair Agreement=.oosRo,,e .-IIIIIIIlllllll!l!llllllll=,B Brackets.oxBolts Tools Required for Assembly Install SeatTo Removetractor from Carton Unpack Carton Attach Steering WheelAssemble Gaugewheelsto Mower Deck To Attach Nose Roller Checktire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemMowerli Our tractors conform to the safety standards of the American Howto Useyourtractor to SET Parking Brake Stopping Mower BladesGround Drive EngineTo Adjust Gauge Wheels To Operate MowerTo Operate on Hills To TransportTo Start Engine ViscosityADD Gasoline Warm Weather StartingPurgetransmission MowingtipsMaintenanceschedule Lubrication ChartGeneral Recommendations Before Each USETractor To Clean Battery and Terminals BeltsTransaxle Cooling Transaxle Pump FluidClean AIR Screen To Service PRE-CLEANERAIR Filter Engine OIL FilterCleaning MufflerSpark Plugs IN-LINE Fuel FilterTo Install Mower Tractor To Remove MowerSIDE-TO-SIDE Adjustment TolevelmowerhousingBoth Front Links Must be Equal Length To Adjust Brake To Replace Mower Blade Drive BeltTo Adjust Steering Wheel ALIGN- Ment To Replace Motion Drive BeltTransmission REMOVAIJREPLACE- Ment Front Wheel TOE-IN/CAMBERReplacing Battery To Attachjumper CablesTo Remove CABLES, Reverse Order To Replace Headlight LampTo ADJUSTTHROnLE Control Cable Adjustment is necessary, proceed as followsTo Adjust Choke Control To Adjust CarburetorTractor BatieryEngine Fuel System Engine OILCause TroubleshootingchartCorrection Troubleshoong Chart ProblemCause CorrectionTroubleshooting Chart OFFSchematic Tractor - Model NumberElectrical Tractor --MODEL Number KEY Part DescriptionTRACTOR- Model Number Chassis and Enclosures Tractor - Model Number 917.272261 Chassis and Enclosures 30 175692X615 Fender/FootrestTRACTOR- Model Number Ground Drive Tractor Model Number Ground Drive 74713TRACTOR-- MODELNUMBER917.272261 Steeringassembly TRACTOR--MODEL Number Steeringassembly KEY Part NO. NO.DESCRIPTIONOptional Equipment Spark Arrester25 175440X505 Cheke Contro TRACTOR--MODELNUMBER917.272261 Seatassembly Decals Wheels &TIRESTRACTORMODELNUMBER917--.272261 Liftassembly TRACTOR- Model Number Liftassembly TRACTOR- Model Number Mowerdeck Tractor - Model Number Mowerdeck MmO Drag 711dxl,15odx.030thkPage 80810T7I 20 m WjtoThrettle Control Page Page Suggested Guide for Sighting Slopes for Safe Operation PART6&m.-11 p.m,,7daysawek 179175 3.22.01 TR

917272261 specifications

The Craftsman 917272261 is a powerful and versatile lawn tractor designed for homeowners who want to maintain their lawns efficiently and effortlessly. This riding mower boasts a variety of features that make it an excellent choice for tackling different yard sizes and types. Its robust build and innovative technologies ensure a reliable performance every time.

One of the main features of the Craftsman 917272261 is its 19 HP Briggs & Stratton engine. This reliable engine provides the necessary power to handle even the toughest mowing tasks, allowing users to navigate through thick grass and uneven terrain with ease. The engine is also designed for fuel efficiency, helping homeowners save on fuel costs while still getting the job done effectively.

The 42-inch cutting deck is another standout feature of the Craftsman 917272261. This wide cutting width allows for efficient mowing, reducing the number of passes required to cover the entire lawn. The cutting deck is also equipped with adjustable heights, offering seven different positions that allow users to customize the height of their grass cut. This feature helps to create a neat and healthy lawn, accommodating various grass types and preferences.

Technologies integrated into the Craftsman 917272261 ensure a smooth and easy operation. The manual transmission system allows users to choose their speed, providing a tailored mowing experience. Additionally, the inching pedal enables gentle speed control, allowing for precise maneuvering around corners and obstacles.

For added convenience, the Craftsman 917272261 includes a comfortable and spacious operator's seat, designed to reduce fatigue during long mowing sessions. The tractor is also equipped with a reinforced frame, making it durable enough to withstand the rigors of regular use.

Several accessories can enhance the functionality of the Craftsman 917272261. Optional attachments such as baggers, mulching kits, and snow blades turn this versatile lawn tractor into an all-season tool, making it capable of tackling a variety of outdoor chores.

In conclusion, the Craftsman 917272261 is a reliable, feature-rich lawn tractor that combines power, efficiency, and user-friendly technologies. Its strong engine, adjustable cutting deck, and comfort-oriented design make it an excellent investment for any homeowner looking to maintain a pristine lawn all year round.