Craftsman 917.38841 owner manual To Assemble Grass Catcher, Carburetor, Engine Speed, Handle

Page 14

TO ASSEMBLE GRASS CATCHER

•Put grass catcher frame into grass bag with rigid part of bag on the bottom. Make sure the frame handle is outside of the bag top.

•Slip vinyl bindings over frame.

NOTE: If vinyl bindings are too stiff, hold them in warm water for a few minutes. If bag gets wet, let it dry before using.

_,CAUTION" Do not run your lawn

mower without clipping deflector or approved grass catcher in place. Never attempt to operate the lawn mower with the rear door removed or propped open.

Catcher frame handle

"_--Frame

opening

ENGINE

CARBURETOR

Your carburetor has a non-adjustablefixed main jet for mixture control. If your engine does not operate properly due to suspected carburetor problems, take your lawn mower to an authorized service center for repair or adjustment.

IMPORTANT: Never tamper with the engine governor, which is factory set for proper engine speed. Overspeeding the engine above the factory high speed setting can be dangerous, if you think the engine-governed high speed needs adjusting, contact your nearest authorized service center, which has proper equipment and experience to make any necessary adjustments.

ENGINE SPEED

Your engine speed has been factory set. Do not attempt to increase engine speed or it may result in personal injury. If you believe that the engine is runningtoo fast or too slow, take your lawn mower to an authorized service center for repair and adjustment.

Immediately prepare your lawn mower for storage at the end of the season or ifthe unit will not be used for 30 days or more.

LAWN MOWER

When lawn mower is to be stored for a period of time, clean it thoroughly,remove all dirt, grease, leaves, etc. Store in a clean, dry area.

•Clean entire lawn mower (See "CLEAN- ING" in the Maintenance section of this manual).

•Lubricate as shown in the Maintenance section of this manual.

•Be sure that all nuts, belts, screws, and pins are securely fastened, inspect moving parts for damage, breakage and wear. Replace if necessary.

•Touch up all rusted or chipped paint

surfaces; sand lightly before painting.

HANDLE

You can fold your lawn mower handle for storage.

•You can fold your lawn mower handle for storage.

•Loosen the two (2) handle knobs on sides

of the upper handle and allow handle to fold down to the rear.

•Squeeze the bottom ends of lower handle toward each other until pins in handle clear

the brackets and pivot entire handle

assembly forward and allow it to rest on mower.

•When setting up your handle from the

storage position, the lower handle will require manually locking into the mowing position.

IMPORTANT: When folding the handle for storage or transportation, be sure to fold the handle as shown or you may damage the control cables.

Operator Presence

Control Bar

Upper

Handle_'Nx"

Fold Forward _:,6"///

For Storage _

' !IV *"

.,, Fold

_ Backward

Mowing

Position

Lower Handle

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Riiftxmiin SEARS, Roebuckand CO., D/817 WA, Hoffman ESTATES, Illinois Limited TWO Year Warranty on Craftsman Power MowerBack Cover TrainingOperation Maintenance and StorageALook for this symbol to point out To Remove Lawn Mower from Carton Lawn Mower PerformanceLawn Mower MAINTENANCl To Install Attachments To Unfold HandleKnow Your lAWN Mower Howto Useyour Lawn Mower Engine Speed Control Engine Zone ControlTo Convert Mower Rear BaggingTo Start Engine Before Starting Engine OILAddgasoune Mowingtips Mulching Mowing TipsGeneral Recommendations Maintenance ScheduleLubrication Chart Before Each USEExhaust OIL CapacityChampion RJ19LM Or J19LM Valve Clearance Intake Solid State Ignition AIR GAPTo Sharpen Blade Grass CatcherTo Change Engine OIL AIR FilterSparkplug Lawn Mower To Adjust Cutting HeightCleaning MufflerCarburetor EngineTo Assemble Grass Catcher Engine SpeedEngine OIL Troubleshooting ChartProblem Cause Correction CylinderTroubleshooting Chart Problem Cause Page Craftsman Rotary Lawn Mower --MODEL no Craftsman Rotary Lawn MOWER-- Model no KEY Part NO. NO.DESCRIPTION245 Craftsman Cycle Engine Model 36A 632766 Carburetor Tube Craftsman 4-CYCLE Engine Model no174409 03.09.00 VB Printedin U.S.A

917.38841 specifications

The Craftsman 917.38841 is a robust lawn mower that has garnered attention for its efficiency, versatility, and user-friendly features. Designed for homeowners seeking a reliable solution for maintaining their lawns, this model balances power and comfort while achieving outstanding cutting results.

One of the standout features of the Craftsman 917.38841 is its powerful engine. Equipped with a dependable 15.5 HP Briggs & Stratton engine, it provides ample power, allowing the mower to handle tough grass and uneven terrains with ease. This ensures that your mowing tasks are completed quickly and without unnecessary stress on the machinery.

The mower incorporates a 42-inch cutting deck, which allows for wider mowing coverage in a single pass. This deck size is ideal for medium to large yards, enabling users to save time without compromising on cut quality. The cutting height can be easily adjusted to six different positions, ranging from 1.5 to 4 inches, which gives users the flexibility to suit their lawn’s specific needs throughout the mowing season.

Another key characteristic of the Craftsman 917.38841 is its ease of use. The mower features an ergonomic seat and steering wheel, allowing for comfortable navigation during extended mowing sessions. Additionally, its automatic transmission offers seamless speed control, which allows users to easily adjust their pace according to the mowing conditions.

The inclusion of six different-speed settings provides the user with enhanced control over the mowing speed, making it easier to navigate around obstacles and flower beds while ensuring an even cut. Moreover, the model features a tight turning radius, enhancing maneuverability in tight spaces.

To further ensure durability and performance, the Craftsman 917.38841 has a sturdy, reinforced frame. This durability not only contributes to the mower's longevity but also ensures it can withstand the rigors of regular use in various yard conditions.

Maintenance is straightforward with this mower, thanks to its accessible features. The design allows for easy access to the engine and the cutting deck, making routine maintenance tasks simple.

In summary, the Craftsman 917.38841 combines power, efficiency, and user-centered design. With its reliable engine, extensive cutting options, and user-friendly features, it stands out as an excellent choice for homeowners looking to maintain a pristine lawn with ease and efficiency. Whether you're navigating tight corners or tackling thick grass, this mower is engineered to deliver exceptional performance consistently.
Top Page Image Contents