Assembling VAC Parts

13.Flip the cart over so that it rests on its wheels.

14.Assemble the front tongue on top of the rear tongue using three 3/8" x 3" hex bolts and 3/8" nylock nuts.

See figure 8.

HINT: For easier assembly, support the rear tongue with a block of wood.

		3/8" x 3"
	_ %	HEX BOLT
_	_ o	TONGUE
		(FRONT)

/÷ \

3/8" NYLOCK NUT

BLOCK

FIGURE 8

15.Assemble the hitch bracket to the front tongue us- ing two 3/8" x 1-1/4" hex bolts and 3/8" nylock nuts. Tighten. See figure 9.

18.Secure the hitch pin to the hitch bracket and tongue with the hair cotter pin. See figure 9.

	HITCH BRACKET	HITCH
	\	HITCH
	\	/
		PIN

HAIR

COTTER

rPIN

/®/

3/8" NYLOCK NUT

TONGUE

FIGURE 9

17.Release the latch lock lever and tilt the cart bed back. See figure 10.

18.Assemble the front panel to the cart bed, sliding the bottom lip of the panel in between the cart bed and the latch stand bracket. Fasten the panel to the bottom and sides of the cart bed using six 1/4" x 5/8" hex bolts and 1/4" nylock nuts. Tighten. See figure 10.

19.Tighten the two bolts that you assembled to the latch stand bracket in figure 5.

FRONT\

	PANEL	\
	PANEL	114"NYLOCK NUT
		114"NYLOCK NUT
		\\
		\
		114" x 5/8"
		HEX BOLT

114" x 5/8"

HEX BOLT

1/4"NYLOCK NUT

/LATCH STAND

FIGURE 10