ASSEMBLING THE DECK ADAPTER (#62468)
TOTHE MOWER DECK
Contents of Hardware Pack for Deck Adapter:
See Figure | 23. |
|
|
|
|
Key | Qty. | Description |
| ||
A | 2 | Hex Bolt, 5/16" x 1" | |||
B | 4 | Hex Bolt, | 1/4" x 3/4" | ||
C | 2 | Carriage | Bolt, 5/16" x 3/4" | ||
D | 3 | Nylock | Nut, 5/16" |
| |
E | 4 | Nylock | Nut, 1/4" |
| |
F | 3 | Flat Steel Washer, | 1/4" Std. | ||
G | 12 | Flat Washer, 5/16" | Std. | ||
H | 5 | Nylon Washer |
| ||
I | 1 | Mounting | Strap |
| |
J | 1 | Angle | Bracket |
| |
K | 1 | Mounting | Bracket |
| |
C
CAUTION: Mower deflector must be
replaced when
FiTTiNG TO SEARS TRACTORS
(and other tractors listed on white fold out sheets)
If you have a Murray brand tractor with a 38", 40" or 46" deck, go directly to instructions on page 16.
ATTENTION: The yellow fold out sheet contains the templates for Sears tractors.
,Identify your mower deck (see fold outs) and cut out the correct discharge opening template for your mower deck size. If there is no template for your deck size you can make your own template by marking around a piece of cardboard held against the edge of the discharge opening.
,Tape the template to the face of the adapter, locating template approximately 1/2" from front and 1/4" down from top of adapter. Keep as close to top as possible. See figure 24. Mark outline of template on face of adapter using white crayon, nail or scriber. Drill a starting hole inside the outline, then use a saber saw or key hole saw to cut out the opening. See figure 24.
1/4" DOWN
IMPORTANT: Keep
the top edge as possible,
NOT SHOWN FULL SIZE
FIGURE 23- FULL SIZE
NOTE: Not all of the hardware will be used for any one particular fit up.
1.Remove the mower discharge deflector from your mower deck. Save the deflector and hardware for remounting.
1/2" FROM FRONT
FIGURE 24
14