,Position the adapter over the deck opening, and check for fit of cutout as shown in figure 25. Trim cutout, if necessary, to allow tilting of adapter, keeping the fit as close as possible for best vacuum suction.
NOTE: Make sure adapter clears gauge wheels on mower deck
6.Assemble the adapter bracket to the deck using two 5/16" x 1" hex bolts, 5/16" flat washers and 5/16" nylock nuts. See figure 27.
NOTE: It may be necessary to use extra 5/16" flat washers to shim under the bracket next to the deck
surface. Ten extra washers have been furnished as
DECK ADAPTER
MOWER DECK
shims. See figure 27.
'j(
®,
2) 5/16" NYLOCK NUTS
,/I
Curl on deck may be located outside of adapter or inside depending on deck opening design
FIGURE 25
5, Holding the adapter bracket and the deck adapter together, position the deck adapter on the mower deck. Keeping the edge of deck adapter as close as possible to the offset in the adapter bracket, see if the slot in the adapter bracket can be aligned with one or two of the deflector holes in your mower deck's discharge opening. If the bracket can not be located correctly using existing holes, it will be necessary to drill one or two 5/16" diameter holes in the deck. See figure 26.
Use existing holes or drill 5/16" diameter hole or holes.
ADAPTER BRACKET
"\ I
\
\\\\\\
\\
\
DECK ADAPTER | MOWER DECK |
Keep edge of adapter as close
as possible to offset in bracket
FIGURE 26
ADAPTER BRACKET
5/16" flat washers used as needed for
5/16" x 1" HEX BOLT/_ | shims to | adjust for |
| variations | in decks. |
FIGURE 27 |
|
|
7, With deck adapter positioned correctly over the discharge opening, use the adapter bracket as a template and drill three 9/32" diameter holes in the top of the deck adapter. See figure 28.
,Bolt deck adapter to bracket using three 1/4" x 3/4" bolts, nylon washers, 1/4" flat washers and 1/4" lock nuts. Nylon washers should be against the inside of the deck adapter. See figure 28.
DECK ADAPTER
|
|
| (3) 1/4" NYLOCK |
|
|
| NUTS |
|
| _/ | ADAPTER |
|
| _____._ | BRACKET |
(3) NYLON | / | _ | MOWER DECK |
WASHERS |
|
|
|
(3) 1/4" STEEL WASHERS
(3) 1/4" x 3/4" HEX BOLTS
FIGURE 28
,Assemble end of hose and a hose clamp over the
round opening of deck adapter and tighten clamp. GO DIRECTLY TO THE OPERATION INSTRUCTIONS
ON PAGE 18.
15