To Assemble Grass Catcher, Fully seated

Lower Handle

Squeezeto \ _" F

remove_Handle Bracket

Hairpin Cotter

TO ASSEMBLE GRASS CATCHER

•Insert leg of tubular frame through front

opening of grass catcher and thread frame into sewn hem of bag.

NOTE: Keep bag hem gathered on the straight leg of the tubular frame.

•When frame comes out the other end of sewn hem, immediately work the end of

frame down inside the bag as shown in inset.

•Slide sewn hem evenly around the tubular frame until both ends of frame

are exposed out of the front opening.

•Assemble lower frame to tubular frame as shown. Be sure handle is outside of

bag and frames are fully seated as shown in inset.

•Slip vinyl bindings over frame.

NOTE: if vinyl bindings are too stiff, hold them in warm water for a few minutes. If

bag gets wet, let it dry before using.

•Close the flip lid. Flip lid must be closed

while operating lawn mower.

•,CAUTION: Do not run your lawn mower without clipping deflector or approved grass catcher in place. Never attempt to operate the lawn mower with the rear door removed or propped open.

Lower frame

_Framesmustbe

_-- _._

I fully seated)

Tubular frame

Lower frame handle

ENGINE

CARBURETOR

Your carburetor has a non-adjustable fixed main jet for mixture control. If your engine does not operate properly due to sus-

pected carburetor problems, take your lawn mower to an authorized service

center for repair or adjustment.

ENGINE SPEED

Your engine speed has been factory set. Do not attempt to increase engine speed or it may result in personal injury. If you believe that the engine is running too fast or too slow, take your lawn mower to an authorized service center for repair and adjustment.

Tubular fra_

_ewn

hem

Se 1 hem

Fli _ lid