CLEANING
iMPORTANT: For best performance,keep mower housingfree of
trash. Clean the undersideof your mower after each use.
_CAUTION: Disconnectspark plug wire from spark plug and place wire where it
cannot come in contact with plug.
•Clean the underside of your mower by scraping to remove
Clean engine often to keep trash from
accumulating. A clogged engine runs hotter and shortens engine life.
Keep finished surfaces and wheels free of all gasoline, oil, etc.
We do not recommend using a garden hose to clean lawn mower unless the electrical system, muffler, air filter and carburetor are covered to keep water out. Water in engine can result in short- ened engine life.
AWARNING: | To avoid serious injury, before performing any service or adjustments: |
1.Release control bar and stop engine.
2.Make sure the blade and all moving parts have completely stopped.
3.Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.
LAWN MOWER
TO ADJUST CUTTING HEIGHT
See "TO ADJUST CUTTING HEIGHT" in the Operation section of this manual.
SQUEEZE
TO ADJUST
REAR DEFLECTOR
The rear deflector, attached between the rear
Handle Mounting pin Hairpin cotter
wheels of your mower, is provided to minimize the possibility that objects will be thrown out of the rear of the mower into the operator's mowing position. If the deflector becomes damaged, it should be replaced.
rf
L
DISCHARGE GUARD
The discharge guard, attached to the discharge opening of your lawn mower, is provided to prevent the possibility of injury resulting from objects being thrown out of the discharge opening into the operator mowing position. If the discharge guard becomes damaged, it should be replaced.
Mowing | r_ | Mowing |
_,, position | [ | position |
Hairpin \\\_._)X[ | "_ | \ |
cotter | IFHand'e | |
Mounting'] | L_ | bracket |
TO ADJUST HANDLE | pin | LOW POSITION | HIGH POSITION |
|
|
| |
The handle can be mounted in a high or |
|
|
|
low position. The mounting holes in the |
|
|
|
bottom of lower handle are off center for |
|
|
|
raising or lowering the handle. |
|
|
|
1.Remove upper handle and all wire tie(s) securing cable(s) to lower handle.
2.Remove hairpin cotters from lower handle bracket mounting pin.
3.Squeeze lower handle in to remove it
from mounting pins. | \ |
4.Turn lower handle over to raise or lower
handle. |
|
| Lower |
5. Squeezelowerhandlein | and position holes | handle | |
| |||
onto mounting | pins on handle bracket. | ROTATE | |
|
|
| |
6.Reassemble upper handle and all parts
removed from lower handle. | 13 |