Craftsman 358.79476 Replace Spark Plug, Check Muffler Mounting Screws, Carburetor Adjustment

Page 12

REPLACE SPARK PLUG

Replace spark plug each year to ensure the engine starts easier and runs better. Set spark plug gap at 0.025 inch. Igni- tion timing is fixed, nonadjustable.

1. Twist, then pull off spark plug boot.

2.Remove spark plug from cylinder and discard.

3.Replace with Champion RCJ-6Y spark plug and tighten securely with a 3/4 inch socket wrench.

4.Reinstall the spark plug boot.

REPLACE FUEL FILTER

To replace fuel filter, drain unit by run- ning it dry of fuel, then remove fuel

cap/retainer assembly from tank. Pull filter from tank and remove it from the

fuel line. Install new fuel filter on fuel line; reinstall parts.

Fuel U

'/

Fuel Filter_

__ _,_

CHECK MUFFLER MOUNTING

SCREWS

Once each year, ensure muffler mounting screws are secure and tight- ened properly to prevent damage.

Muffler Cover

_1SparkArresting

Hood

Screws

Replace the spark arresting screen ev- ery 50 hours of operation or if any dam- age or breaks in the screen are noted.

NOTE: Do not attempt to clean the spark arresting screen.

1.Remove 3 screws from muffler cov- er. Remove muffler cover.

2.Loosen and remove 4 screws from the muffler hood.

3.Remove the muffler hood and spark arresting screen.

4.Install new spark arresting screen.

5.Reinstall muffler hood and 4 screws. Tighten screws securely.

6.Reinstall muffler cover and 3

screws. Tighten securely. NOTE: If any part of the muffler is cracked, broken or damaged, we rec- ommend that the muffler be replaced.

CARBURETOR ADJUSTMENT

The carburetor has been carefully set at the factory. Adjustments may be necessary if you notice any of the fol- lowing conditions:

Engine will not idle when the throttle is released.

Idle Speed Adjustment

Allow engine to idle. Adjust speed until engine runs without stalling (idle speed too slow).

Turn idle speed screw clockwise to

increase engine speed if engine stalls or dies.

• Turn idle speed screw counterclock- wise to decrease engine speed.

Screw/_-_

Muffler

Idle Speed _"_"_/

Mounting Screw

 

INSPECT MUFFLER AND SPARK

 

ARRESTING SCREEN

 

_ WARNING: The muffler on this

product contains chemicals known to the State of California to cause cancer.

As the unit is used, carbon deposits build up on the muffler and spark ar- resting screen, and must be removed to avoid creating a fire hazard or af- fecting engine performance.

-12-

Air J W / _=_

cover _jZC 2::

If you require further assistance or are unsure about performing this proce-

dure, contact your Sears Service Cen- ter or call our customer assistance

help line at 1-800-235-5878.

Image 12
Contents Crrftsmrni TWO Year Full Warranty on CRAFTSMAN@ GAS Blower Sears, Roebuck and Co., Hoffman Estates, ILIwarning @@1 Know Your UnitPlan Ahead Handle Fuel with CAUTION, IT is Highly FlammableOperate Your Unit Safely Assembly Maintain Your Unit ProperlyModel Special Notice This unit isBlower Assembly Blower Tube Assembly Vacuum Assembly Vacuum BAG AssemblyHIGH-SPEED Nozzle Assembly Vacuum Tube AssemblyHOW to Convert Unit from Vacuum USE to Blower USE Blower Tube AssemblyVacuum BAG Shoulder Strap Adjustment Blower USE I Vacuum USE Know Your BlowerThrottle Trigger Throttle Position LeverOperating Tips Operating PositionBefore Starting Engine Fueling EngineHOW to Stop Your Engine HOW to Start Your EngineStarting a Cold Engine Starting a Warm EngineCare & Maintenance Task Customer ResponsibilitiesCarburetor Adjustment Idle Speed AdjustmentReplace Spark Plug Check Muffler Mounting ScrewsSeasonal Storage Fuel SystemEngine OtherTroubleshooting Table CauseYour Warranty Rights and OB MAINTENANCE, Replacement and Repair of Emission RE El I 81Repair Parts =/=F=¢ z Repair Parts Sears, Roebuck and Co., Hoffman Estates, IL Conozca SU Aparato Piense Antes DE Proceder Haga USO Seguro DE SU AparatoHaga EL Mantenimiento DEL Aparato EN LA Forma Debida Aviso DE Seguridad El estar exModelo MontajeMontaje DE LOS Tubos DEL Soplador Montaje DE LA Boquilla DE Alta Velocidad Montaje DEL Aspirador Montaje DE LA Bolsa DEL AspiradorMontaje DE LOS Tubos DE Aspirador Como Convertir EL Aparato DE USO DE Aspirador a USO DE SopladorAjuste DE LA Banda DEL Hombro Para LA Bolsa DEL Aspirador Montaje DE LA Banda DEL HOM USO DEL Soplador AspiradorConozca SU Soplador Palanca DEL Posicion DE LA AcceleradorPalanca DEL Arrancador Sugerencias UtilesPosicion DE USO Antes DE Poner EL Motor EN MarchaImportante Para Detener EL MotorPara Poner EN Marcha EL Motor Para Arrancar CON Motor FrioPara Arrancar CON EL Motor Caliente Arranque DE Motor AhogadoResponsabilidad DEL Usuario Tarea DE Cuidado Mantenimiento Cuando HacerPiezas Sueltas NI Fijadores Flojos Verificar QUE no Haya Piezas Danadas NI GastadasInspeccione Y Limpie EL Apara To Y SUS Placas Limpie EL Filtro DE AireInspeccione EL Silenciador Y LA Rejilla Antichispas Ajuste AL CarburadorMarcha Lenta Estacional Almacenaje Sistema DE CombustibleMotor OtrosTabla Diagnostica CausaGarantia DE Responsabimdad Plazo DE PIEZAS. La reparaci6n o elPeriodo DE Garantia Cualquier Piezas Anadidas O Modificadas MANTENIMIENTO, Reemplazo Y Reparacion DETrol DE Emision Garantizadas 41 I 61 I 81 IPage Page Page Your Home