Ifyouneedassistance,contactyour FailuretofollowallSafetyRulesand
SearsServiceCenterorcall Precautionscanresultinseriousinjury.
SAVE THESE INSTRUCTIONS
•To reduce the risk of electrical shock, this unit has a polarized plug (one blade is wider than the other) and will require the use of a polarized exten- sion cord. The appliance plug will fit into a polarized extension cord only one way. If the plug does not fit fully into the extension cord, reverse the plug. Ifthe plug still does not fit, ob- tain a correct polarized extension cord. A polarized extension cord will
CARTON CONTENTS
Model 358.748200
•Blower
•Blower Tube
Examine parts for damage. Do not use damaged parts.
NOTE: If you need assistance or find parts missing or damaged, call
,_ WARNING: | If received assembled, |
ensure your unit is properly assembled and all fasteners are secure.
ATTACHING THE BLOWER TUBE
1.Align the grooves on the blower tube with the grooves on the blower outlet.
2.Push the blower tube onto the blower
outlet until it snaps into place (tube is secured by red tube release button).
3.To removethe blowertube, pressthe
tube release button while pulling on tube.
require the use of a polarized wall outlet. This plug will fit into the polar- ized wall outlet only one way. If plug does not fit fully into the wall outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper wall outlet. Do not change the equipment plug, exten- sion cord receptacle, or extension cord plug in any way.
heating can occur causing damage to unit. Refer to table for minimum
wire gauge recommendations. The cord must be marked with the proper wire gauge. (Appropriate extension cords are available.) Do not use mul- tiple cords.
In good condition. Cord insulation must be intact with no cracks or deterioration. Plug connectors must be undamaged. DO NOT use multiple cords.
MINIMUM WIRE GAUGE
RECOMMENDATIONS
VOLTS | 25 FT. | 50 FT. | 100 FT. |
| 18 | 16 | 14 |
120 | A.W.G.* | A.W.G.* | A.W.G.* |
*American Wire Gauge
Secure the extension cord to the unit by threading the cord through the cord re- tainer (see illustration). Insert the cord receptacle into the recessed plug.
CAUTION: Failure to use cord retain- er could result in damage to the unit, extension cord, or both.
Blower outlet | Blower Tube |
SELECT AN EXTENSION CORD
Use only a 120 A.C. voltage supply as shown on nameplate of the unit to power your blower.
The extension cord used to reach the power source must be:
•Specifically marked as suitable for out- door use. The cord must be marked
with the suffix 'M/'.
•Heavy enough to carry full current from the power source to the unit. Otherwise, loss of power and over-
Cord
Receptacle
Cord
Recessed
Plug on Unit