Craftsman 316.35084 manual OraLFILTER, Spark Arrester Screen, Spark Plug

OraLFILTER

NOTE: Drain oil reservoir before changing filter

1.Take the bottom plate off then use a wire with a hook

(A) and puii oii fiiter (B) from reservoir. Remove old fiiter

and replace.

2.Put filter and oil line back into oil reservoir so filter is at Bottom of reservoir.

Fig. 33

SPARK ARRESTER SCREEN

NOTE: A clogged spark arrester screen will dramatically reduce engine performance.

1.To flatten the corners of the lock plate to be able to access the retaining nuts. Remove 2 muffler retaining nuts (E), Lock plate (F) and muffler cover(G) (Fig. 34).

2.Remove spark attester screen (H) from the metal baffle

(J). Replace screen with new one.

3.Reassemble the muffler components and tighten nuts securely.

_ .... G

Fig. 34

SPARK PLUG

NOTE: For efficient operation of saw engine, spark plug

must be kept clean and properly gapped.

1.Push STOP switch up.

2.Remove top Cover. Disconnect the wire connector from the spark plug by pulling and twisting at the same time (Fig. 35).

3.Remove spark plug with spark plug socket wrench.

DO NOT USE ANY OTHER TOOL.

WARNmNG" Do not sand Mast,

• scrape or cban

ebctrodes. Grit in the engine could damage the cylinder.

4.Check electrode gaps with wire feeler gauge and set gaps to .025" (.635mm) if necessary.

5.Reinstall a new spark plug (champion RDJ8J or equiv- alent).

NOTE: A resistor spark plug must be used for replace- ment (part no. 9295-320001).

NOTE: This spark ignition system meets all requirements of the Canadian Interferen-Causing Equipment Regulations.

Fig. 35

CARBURETOR ADJUSTMENT

The carburetor was pre-set at the factory for optimum per- formance, If further adjustments are necessary, please take your unit to a Sears or other qualified service dealer.

19