Craftsman 486.24336 owner manual NUTS4, LOCKWASHERS4

e_÷Attach two hitcharm mount brackets to the middle

_; holes ir_thefr0nt frame angle (bend pointing down) as shown in figure 4. Fasten each bracket with a 5/16" x 3/4" hex bolt, a 5/16" lock washer and a 5/16" plain hex nut. Make sure the brackets are aligned straight and then tighten. See figure 4.

6/16" x 3/4" HEX BOLT

HITCH ARM _

MOUNT BRACKETS _

FRONTFRAME

ANGLE

FIGURE 4

•Assemble two hitch arm mount brackets to _e middle holes in the rear frame angle using two 5/16" x 3/4" hex bolts, two 5/16" lock washers and two 5/16" plain hex nuts. Make sure the brackets are aligned straight and then tighten. See figure 5.

	REAR FRAME	5/'16"
	ANGLE	LOCK
5/16" x 3/4"	\	WASHER
HEX BOLT	\

•Assemble the hitch mount arms to the foul hitch arm_

mount brackets as shown in figura 6. Use f0_5/16! _ 1" carriage bolts, four 5/16" lock washers and four "; '

5/16" plain hex nuts. Do not tighten yeL See figure 6.

5/16" x 1"		HITCH ARM
CARRIAGE	BOLTS (4)	MOUNT
5/16" LOCK		BRACKETS (4)
WASHERS	(4)
5/16" HEX
NUTS(4)

HITCH MOUNT ARMS

FIGURE6

Assemble the ends of the hitch mount arms together using two 5/16" x 1-1/4" hex bolts, two 5/16" lock washers and two 5/16" plain hex nuts as shown in figure 7. Do not tighten yet.

Assemble the hitch brackets to the hitch mount arms usingtwo 5/16" x 2" hex bolts, two 5/16" lock wash- ers and two 5/16" plain hex nuts as shown in figure 7.

Tighten ell loose fasteners which were assembled in figures 6 and 7.

HITCH MOUNT ARMS

i! g--HEX BOLTS (2)

.___)_5/16" x2"

		5/16"	/'	LOCKWASHERS(4)
	5/16"	HEX	_1(_	5/16" HEX NUTS (4)
HITCH ARM		NUT

MOUNT	LOCK	--	5/16" x 1-1/4" HEX BOLTS (2)
	WASHER
BRACKETS
FIGURE 5		FIGURE 7