Orion 3002 manual Amplifier Settings, Stereo / Mono Input Configuration, Low-Pass Crossover

Page 7

AMPLIFIER SETTINGS

Stereo / Mono Input Configuration

The STEREO / MONO switch allows the Orion 2002 and 3002 amplifiers to use a single RCA or high-level input to feed signal to both the right and left channels of the amplifier.

When the switch is to the right (MONO position), signal from the left input is routed to the right channel. This is the preferred mode when bridging the amplifier into a single speak- er. When the switch is to the left (STEREO position), right and left inputs are independent. This allows a source unit with an internal balance to change the stereo imaging.

Internal Crossover Configuration

The crossover section of Orion 2002 and 3002 amplifiers are continuously variable and extremely flexible. There are eight different crossover configurations possible allowing high-pass, low-pass, and band-pass operation. This circuit is designed to optimize the per- formance of subwoofers in all types of enclosures.

When using Orion loudspeakers, minor deviations from the recommended frequency ranges can provide superior results depending on your speaker locations and your vehicle acoustics. Setting crossover frequencies higher than recommended will not cause damage and may provide superior sonic results depending on your system's performance goals. Refer to your loudspeaker owner's manual for assistance in choosing the proper crossover frequencies for your system.

WARNING! DO NOT set crossover frequencies lower than the speakers recommended operating range. This can cause driver failure that is not covered by manufac- turer's warranty.

Low-Pass Crossover

When the switch is to the right (OFF position), the low-pass crossover is bypassed. When the switch is to the left (ON position), the low-pass crossover is active. The low-pass crossover is continuously variable from 20Hz to 3kHz.

6

©2004 Directed Electronics, Inc.

Image 7
Contents Page Contents Practice Safe Sound IntroductionWhat’s in the Box Record Your Serial Number and Date Limited TWO-YEAR Consumer WarrantyAmplifier Section Orion SpecificationsAmplifier Controls and Connections Low-Pass Crossover Amplifier SettingsStereo / Mono Input Configuration Internal Crossover ConfigurationInput Gain High-Pass CrossoverINTELLi Bass Control Power Connections Amplifier WiringSpeaker Connections Summed Bridged Configuration Trunk Compartment Amplifier InstallationChoosing Mounting Locations Passenger CompartmentTools of the Trade General Precautions and Installation TipsStep By Step Installation Testing the System SET UP and TroubleshootingAdjusting the Sound of the System Directed Electronics, Inc Symptom Probable Cause Action To Take Troubleshooting TipsInternal Crossover Configuration Directed Electronics, Inc Warranty

3002 specifications

The Orion 3002 is a highly advanced spacecraft designed for deep-space exploration, research, and potential colonization missions. Boasting cutting-edge technologies and innovative engineering, the Orion 3002 is a hallmark of modern aerospace design, focusing on efficiency, reliability, and adaptability.

One of the primary features of the Orion 3002 is its powerful propulsion system, which employs a hybrid of traditional chemical propulsion and advanced ion thrusters. This combination allows for swift maneuverability within the Earth's atmosphere and efficient long-duration travel in the vacuum of space. The ion thrusters utilize electric fields to accelerate ions, providing a thrust that is highly efficient and capable of extending travel durations.

The spacecraft is constructed using lightweight, durable materials that significantly enhance its structural integrity without impeding performance. The exterior is designed to withstand the harsh conditions of space, including fluctuations in temperature, radiation exposure, and micrometeorite impacts. Additionally, the Orion 3002 is equipped with advanced thermal protection systems that maintain optimal operating conditions for onboard systems and crew.

The Orion 3002 features a cutting-edge avionics suite that integrates artificial intelligence and machine learning algorithms. These systems are capable of real-time data analysis, enabling the spacecraft to make autonomous decisions regarding navigation, course adjustments, and systems monitoring. This level of intelligence not only enhances safety but also allows for more complex mission profiles, including those requiring minimal human oversight.

In terms of crew accommodations, the Orion 3002 prioritizes comfort and functionality. The living quarters are designed to support long-duration missions with ergonomic sleeping arrangements, a fully equipped galley, and dedicated research labs that allow astronauts to conduct a variety of experiments during their travels. Advanced life support systems recycle air and water, ensuring sustainability throughout the mission.

The Orion 3002 also incorporates advanced communication systems that enable seamless, high-bandwidth data transmission over vast distances. This technology employs a series of relay satellites and deep-space communication networks, ensuring that the crew remains connected with mission control and can share their findings efficiently.

In conclusion, the Orion 3002 stands as a testament to human ingenuity and the quest for knowledge beyond our planet. With its blend of advanced technologies, durable construction, and crew-centric design, it is well-equipped to tackle the challenges of deep-space missions, paving the way for future exploratory endeavors that expand our understanding of the universe.