Oregon WRS368 Connecting the Wireless Remote Speaker, Control Panel, LCD Display, Transmitter

EN	CONTROL PANEL
						1.	Clock set
						2.	Mute
	1			5		3.	Volume down
						4.	Audio source selection
	2			6		5.	Remote learner
	3			7		6.	Equalizer
						7.	Volume up
	4				8	8.	Power on / off
	LCD DISPLAY
		1
		2							9
		3
		4							10
		5
		6							11
									12
		7
								13
		8
								14
	1.		Volume bar			9.	Audio sources 1, 2
	2.		Reception status				and 3
	3.		Bass and treble			10. Low-battery indicator
	4. Mute on / off					11. AC power indicator
	5.		Clock			12. Learning		status		-
							confirmed
	6.		Learning function -
						13. Learning		status		-
			volume up
							learning
	7.		Learning function -
						14. Learning		status		-
			volume down

activated

8.Learning function - mute

TRANSMITTER

1

2	4
	5
3

1.Channel switch

2.	Line-in jack (audio source	)
3.	RCA red / white input jack (audio source )
4.	Line-in jack (audio source	)

5.DC IN jack

6

CONNECTING THE WIRELESS REMOTE SPEAKER

CAUTION To avoid being exposed to any radio frequency emission, the Wireless Remote Speaker and Transmitter should be placed at least 20cm (8 in) away from nearby persons.

For the Wireless Remote Speaker to playback audio from up to 3 audio sources, you must first connect each audio source to the Transmitter. For example, you can have your stereo connected as source , your DVD player as source and your TV as the third audio source.

An audio signal is transmitted from the Transmitter to the Wireless Remote Speaker via a radio frequency data channel at a range of up to 30 meters (98 feet). The speaker then regenerates sound from an audio source similar to a speaker that is directly connected to a source.

NOTE The transmitter and speaker should each be set to the same channel to ensure proper signal transmission. If the transmitter is set to A, the speaker should also be set to A. If a second transmitter and speaker is used, the channel for each of these units should be set to B. Simply slide the channel switch to the appropriate channel.

Audio source	Max: 30 meters
	(98 feet)

1 2 3

1.Connecting audio sources to the Transmitter using the supplied Y cable or a standard stereo cable (read following section on "CONNECTING AUDIO SOURCES TO THE TRANSMITTER" for more information)

2.Connecting the AC adaptor to the Transmitter

3.Connecting the AC adaptor or installing batteries to the Wireless Remote Speaker

WRS368 Eng (US) R18 OP 6 7/30/05, 10:51 AM