length is shown in this manual. See SE- LECT AN EXTENSION CORD in the AS- SEMBLY section).
SDo not use multiple cords.
SKeep the extension cord clear of operator and obstacles at all times.
STie cord to cord retainer and connect to recessed plug as shown in this manual to prevent damage to unit and/or extension cord and to reduce the possibility of the extension cord disconnecting from the unit during operation.
SDo not attempt to repair unit. Inspect the
insulation and connectors on the unit and extension cord before each use. If there is any damage, do not use until damage is repaired by your authorized service dealer.
SDo not use the unit if the switch does not turn the unit on and off properly. Have the unit repaired by your authorized service dealer.
S Avoid accidental starting. Be sure the switch is in the OFF position and keep your hand and fingers away from the switch while connecting the unit to the power source or when carrying a unit con- nected to the power source.
S Avoid any body contact with any grounded conductor, such as metal fences, or pipes, to avoid the possibility of electric shock.
S Ground Fault Circuit Interrupter (GFCI) protection should be provided on the cir- cuit or outlet to be used for this unit. Re- ceptacles are available having
SStop the motor immediately if you are ap- proached.
DOUBLE INSULATION
CONSTRUCTION
This unit is double insulated to help pro- tect against electric shock. Double insu- lation construction consists of two sepa- rate “layers” of electrical insulation instead of grounding. Tools and ap- pliances built with a double insulation system are not intended to be grounded. No grounding means is provided on this unit, nor should a means of grounding be added to this unit. As a result, the ex- tension cord used with your unit can be plugged into any standard 120 volt elec- trical outlet. Safety precautions must be observed when operating any electrical tool. The double insulation system only provides added protection against injury resulting from an internal electrical insu- lation failure.
WARNING:
SERVICING OF DOUBLE INSULATED BLOWER/VACUUM
All electrical repairs to this unit, including housing, switch, motor, etc., must be diag- nosed and repaired by qualified service personnel. Replacement parts for a double insulated appliance must be iden- tical to the parts they replace. A double in- sulated appliance is marked with the words “double insulation” or “double insu- lated”. The symbol 
(square within a square) may also be marked on the ap- pliance. Failure to have the unit repaired by authorized service personnel can cause the double insulation construction to become ineffective and result in serious injury.
UNIT/MAINTENANCE SAFETY
SDo not set the unit on any surface except a clean, hard area while the unit is run- ning. Debris such as gravel, sand, dust, grass, etc., could be picked up by the air intake and thrown out through the dis- charge opening, damaging the unit, prop- erty, or causing serious injury to bystand- ers or operator.
S Do not overreach or use from unstable surfaces such as ladders, trees, steep slopes, rooftops, etc. Use extra care when cleaning on stairways. Keep firm footing and balance at all times. Keep hands out of tubes.
SInspect the entire unit before each use for worn, loose, missing, or damaged parts. Do not use until the unit is in proper work- ing order.
S This unit is double insulated. See the
DOUBLE INSULATION CONSTRUCTION
section. Have all internal service per- formed by qualified service repair person- nel to avoid creating a hazard or voiding your warranty.
SHave all maintenance other than the rec-
ommended procedures described in the instruction manual performed by your au- thorized service dealer.
SAlways see your authorized service deal- er to replace a damaged impeller. Parts that are chipped, cracked, broken, or damaged in any other way can fly apart and cause serious injury. Replace dam- aged parts before using the unit.
S Never place any object in the air intake opening as this could restrict proper air flow and cause damage to the unit.
SNever douse the unit with water or other liquids or squirt with a water hose. Clean the unit using a damp cloth. Wipe off with a clean dry cloth. See MAINTENANCE.
SCheck air intake openings and tubes fre- quently, always with the unit stopped and
3