DSpecifically marked as suitable for out- door use. The cord must be marked with the suffix “W”.
DHeavy enough to carry full current from the power source to the unit. Otherwise, loss of power and overheating can oc- cur causing damage to unit. Refer to table for minimum wire gauge recom- mendations. The cord must be marked with the proper wire gauge. (Appropri- ate extension cords are available.) Do not use multiple cords.
DIn good condition. Cord insulation must be intact with no cracks or deterioration. Plug connectors must be undamaged. DO NOT use multiple cords.
MINIMUM WIRE GAUGE
RECOMMENDATIONS
VOLTS | 25 FT. | 50 FT. | 100 FT. |
|
|
|
|
120 | 16 | 16 | 14 |
| A.W.G.* | A.W.G.* | A.W.G.* |
|
|
|
|
*American Wire Gauge
Secure the extension cord to the unit by threading the cord through the cord re- tainer (see illustration). Insert the cord receptacle into the recessed plug.
CAUTION: Failure to use cord retain- er could result in damage to the unit, extension cord, or both.
Cord Receptacle
Recessed Plug on Unit
Cord
Retainer
USING YOUR UNIT
KNOW YOUR ELECTRIC BLOWER/VACUUM
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT. Compare the illustrations to your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.
ON/OFF Switch | Top Handle | |
|
| |
|
| Collection Bag |
Cord |
| Air Vents |
Retainer |
| Elbow |
|
| Tube |
Rear |
| Upper Vacuum Tube |
Handle |
| |
| Retaining Post | |
| Inlet Cover | |
| Vacuum Assist Handle | |
| Latch | |
|
| |
|
| Upper Vacuum Tube |
| Tube Release Button | |
|
| Blower Tube |
|
| Lower Vacuum Tube |
| Inlet Restrictor |
|
ON/OFF SWITCH | INLET COVER LATCH |
The ON/OFF SWITCH is used to activate | The INLET COVER LATCH is used to open |
the motor. | and close the inlet cover and to secure |
| the upper vacuum tube to the blower |
| unit. |
7