Weed Eater 545186783 instruction manual Safety Rules

Page 3

SAFETY RULES

WARNING: Failure to follow all Safety Rules and Precautions can result in serious injury.

KNOW YOUR UNIT

SRead your instruction manual carefully until you completely understand and can follow

all warnings and safety rules before operat- ing the unit.

DRestrict unit to users who understand and will follow all warnings and safety rules in this manual.

WARNING: Inspect the area before starting the unit. Remove all debris and hard objects such as rocks, glass, wire, etc. that can ricochet, be thrown, or otherwise cause injury or damage during operation.

DUse your unit as a blower for:

D Sweeping debris or grass clippings from driveways, sidewalks, patios, etc.

D Blowing grass clippings, straw, or leaves into piles, around joints, or between bricks.

PLAN AHEAD

DAlways wear eye protection when operating, servicing, or performing maintenance on unit. Wearing eye protection will help to prevent rocks or debris from being blown or ricochet- ing into eyes and face which can result in blindness and/or serious injury. Eye protec-

tion should be marked ANSI Z87.

D Always wear foot protection. Do not go barefoot or wear sandals.

DAlways wear respirator or face mask when

working with unit in dusty environments.

DSecure hair above shoulder length. Secure or remove jewelry, loose clothing, or clothing with loosely hanging straps, ties, tassels, etc.

They can be caught in moving parts.

DDo not operate unit when you are tired, ill, up- set, or if you are under the influence of alco-

hol, drugs, or medication.

D Keep children, bystanders, and animals away from work area a minimum of 30 feet (10 meters) when starting or operating unit. Do not point blower nozzle in the direction of people or pets.

HANDLE FUEL WITH CAUTION, IT IS HIGHLY FLAMMABLE

DEliminate all sources of sparks or flame (in- cluding smoking, open flames, or work that

can cause sparks) in the areas where fuel is mixed, poured, or stored.

DMix and pour fuel in an outdoor area; store fuel in a cool, dry, well ventilated place; use an approved, marked container for all fuel pur-

poses.

DDo not smoke while handling fuel or while

operating the unit.

DMake sure the unit is properly assembled

and in good operating condition.

DDo not fill fuel tank while engine is running. D Avoid spilling fuel or oil. Wipe up fuel spills be-

fore starting engine.

DMove at least 10 feet (3 meters) away from fuel and fueling site before starting engine.

D Always store gasoline in a container ap- proved for flammable liquids.

OPERATE YOUR UNIT SAFELY

D Inspect unit before each use for worn, loose, missing, or damaged parts. Do not use until unit is in proper working order.

D Keep outside surfaces free from oil and fuel.

DNever start or run engine inside a closed

room, building or other unventilated area. Breathing exhaust fumes can kill.

D To avoid static electricity shock, do not wear rubber gloves or any other insulated gloves while operating unit.

D Do not set unit on any surface except a clean, hard area while engine is running. Debris such as gravel, sand, dust, grass, etc. could be picked up by the air intake and thrown out through discharge opening, damaging unit, property, or causing serious injury to bystanders or operator.

DAvoid dangerous environments. Do not use in unventilated areas or where explosive vapors or carbon monoxide build up could

be present.

DDo not overreach or use from unstable sur- faces such as ladders, trees, steep slopes, rooftops, etc. Keep firm footing and balance

at all times.

D Never place objects inside the blower tubes; always direct the blowing debris away from people, animals, glass, and solid objects such as trees, automobiles, walls, etc. The force of air can cause rocks, dirt, or sticks to be thrown or to ricochet which can hurt people or animals, break glass, or cause other damage.

D Never run unit without the proper equip- ment attached. When using your unit as a blower, always install blower tube.

DCheck air intake opening and blower tube frequently, always with engine stopped and spark plug disconnected. Keep vents and discharge tubes free from debris which can accumulate and restrict proper air flow and

cause damage to the unit.

DNever use for spreading chemicals, fertiliz-

ers, or other substances which may contain toxic materials.

DTo avoid spreading fire, do not use near leaf

or brush fires, fireplaces, barbecue pits, ashtrays, etc.

DUse only for jobs explained in this manual.

MAINTAIN YOUR UNIT PROPERLY

DHave all maintenance other than the rec- ommended procedures described in the in- struction manual performed by an autho-

rized service dealer.

D Disconnect spark plug before performing maintenance except for carburetor adjust- ments.

-- 3 --

Image 3
Contents Manual de Instrucciones Manuel d’Instructions Identification of Safety Symbols Safety Rules Blower Tube AssemblyAssembly OperationOperating Position Throttle LeverPrimer Bulb Choke LeverGeneral Recommendations MaintenanceStarting Position Starting a Warm EngineStorage Troubleshooting Table Cause Remedy EngineOther Canada, contact Limited WarrantyConsequential Damages Weed EAT

545186783 specifications

The Weed Eater 545186783 is a cutting-edge string trimmer designed for homeowners and landscaping enthusiasts who seek efficiency and convenience in their lawn care routines. This versatile tool stands out due to its powerful performance and user-friendly features, making it an essential addition to any gardening toolkit.

One of the key features of the Weed Eater 545186783 is its robust 25cc engine, which delivers ample power for tackling tough overgrowths and maintaining a pristine lawn. The engine is designed for easy starting, thanks to its simplified pull-start mechanism that reduces the effort required to get the trimmer up and running. This ensures that users spend less time preparing their equipment and more time enjoying their outdoor spaces.

The ergonomics of the Weed Eater 545186783 are noteworthy, as it includes an adjustable handle that can be customized for optimum comfort. Its lightweight design allows for prolonged use without causing fatigue, which is particularly beneficial for larger lawn care tasks. The trimmer is equipped with a dual-line bump head that automatically feeds new line as needed, minimizing interruptions during operation and enhancing productivity.

This model also incorporates advanced technology in its design, such as the "Easy Start" system that further simplifies ignition. Users can experience a more hassle-free starting process, making it more approachable for those new to using string trimmers. This system leads to a quicker, smoother experience, allowing trimmers to get to work with minimal frustration.

Durability is another hallmark of the Weed Eater 545186783, as it is built with high-quality materials intended to withstand the rigors of landscaping tasks. The robust construction ensures longevity, even when used on challenging terrains or tough vegetation.

Additionally, safety features like the protective guard enhance user security by preventing debris from being thrown during operation. When combined with a low vibration design, these elements contribute to a safer and more controlled user experience.

In summary, the Weed Eater 545186783 serves as an excellent tool for anyone looking to simplify their lawn care process. With a powerful engine, ergonomic design, innovative starting technology, and safety features, this string trimmer promotes ease of use and reliability, making it a top choice for effective gardening and landscaping.