Weed Eater 187637 Service And Adjustments, TO REMOVE MOWER See Fig, TO INSTALL MOWER See Fig

Page 19
SERVICE AND ADJUSTMENTS

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS:

•Depress clutch/brake pedal fully and set parking brake.

•Place gearshift lever in neutral (N) position.

•Place attachment clutch in “DISENGAGED” position.
•Turn ignition key to “STOP” and remove key.
•Make sure the blades and all moving parts have completely stopped.

•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TRACTOR

TO REMOVE MOWER (See Fig. 15)

Mower will be easier to remove from the right side of tractor.

•Place attachment clutch in “DISENGAGED” posi- tion.

•Move attachment lift lever forward to lower mower to its lowest position.

•Roll belt off engine pulley.

•Remove small retainer spring, and remove clutch spring off pulley bolt.

•Remove large retainer spring, slide collar off and push housing guide out of bracket.

•Disconnect anti-swaybar from chassis bracket by re- moving retainer spring.

•Disconnect suspension arms from rear deck brackets by removing retainer springs.

•Disconnect front links from deck by removing retainer springs.

•Raise lift lever to raise suspension arms. Slide mower out from under tractor.

FLAT WASHER

CLUTCH SPRING

SMALL RETAINER SPRING

CLUTCH SPRING

RETAINER SPRING

ANTI-SWAY BAR

IMPORTANT: IF AN ATTACHMENT OTHER THAN THE MOWER DECK IS TO BE MOUNTED ON THE TRAC- TOR, REMOVE THE FRONT LINKS AND HOOK THE CLUTCH SPRING INTO SQUARE HOLE IN FRAME.

TO INSTALL MOWER (See Fig. 15)

•Raise attachment lift lever to its highest position.

•Slide mower under tractor with deflector shield to right side of tractor.

•Lower lift lever to its lowest position.

•Connect front links to mower deck and secure with retainer springs.

•Connect suspension arms to rear deck brackets and secure with retainer springs.

•Connect anti-swaybar to chassis bracket and secure with retainer spring.

•Push clutch cable housing guide into bracket, slide col- lar onto guide and secure with large retainer spring.

•Place flat washer and clutch spring on idler pulley bolt and secure with small retainer spring.

•Install belt onto engine pulley.

SMALL

RETAINER SPRING

SUSPENSION ARMS

SQUARE HOLE

ENGINE PULLEY

FRONT LINK

RETAINER SPRINGS (BOTH SIDES)

COLLAR

HOUSING GUIDE

LARGE RETAINER

DEFLECTOR SHIELD

 

SPRING

 

 

 

BRACKET

FIG. 15

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents MODEL NO. WET1338B 13 HP 38 Inch Lawn Tractor I. GENERAL OPERATION SAFETY RULESIV. SERVICE Safe Operation Practices for Ride-On MowersNever carry passengers or children even with the blades off 9-13 TABLE OF CONTENTSPRODUCT SPECIFICATIONS CUSTOMER RESPONSIBILITIESKeys UNASSEMBLED PARTSSteering Wheel SeatBEFORE REMOVING TRACTOR FROM SKID ASSEMBLYTOOLS REQUIRED FOR ASSEMBLY TO REMOVE TRACTOR FROM CARTONINSTALL SEAT See Fig HOW TO SET UP YOUR TRACTORCHECK BATTERY See Fig CHECK BRAKE SYSTEM CHECK TIRE PRESSURECHECK DECK LEVELNESS CHECK FOR PROPER POSITION OF ALL BELTSOPERATION KNOW YOUR TRACTOR TO USE THROTTLE CONTROL See Fig HOW TO USE YOUR TRACTORTO ADJUST MOWER CUTTING HEIGHT See Fig TO SET PARKING BRAKE See FigTO TRANSPORT BEFORE STARTING THE ENGINETO OPERATE MOWER See Fig TO OPERATE ON HILLSTO START ENGINE See Fig MOWING TIPSBEFORE EACH USE MAINTENANCELUBRICATION CHART GENERAL RECOMMENDATIONSOPERATOR PRESENCE SYSTEM TRACTORBRAKE OPERATION TIRESTRANSAXLE COOLING BATTERYENGINE V-BELTSENGINE COOLING FINS See Fig CLEAN AIR SCREENAIR FILTER See Fig IN-LINE FUEL FILTER See Fig CLEANINGMUFFLER SPARK PLUGSDepress clutch/brake pedal fully and set parking brake SERVICE AND ADJUSTMENTSTO INSTALL MOWER See Fig TO REMOVE MOWER See FigTO REPLACE MOWER BLADE DRIVE BELT See Fig TO LEVEL MOWER HOUSINGBOTH FRONT LINKS MUST BE EQUAL IN LENGTH FRONT WHEEL TOE-IN/CAMBER TO CHECK AND ADJUST BRAKE See FigTO ADJUST STEERING WHEEL ALIGN MENT TO REPLACE MOTION DRIVE BELT See FigREPLACING BATTERY See Figs. 25 and TO START ENGINE WITH A WEAK BATTERY See FigTO REMOVE WHEEL FOR REPAIRS See Fig TO REPLACE HEADLIGHT BULB TO REMOVE HOOD AND GRILL ASSEMBLY See FigTO ADJUST THROTTLE CONTROL CABLE See Fig TO ADJUST CARBURETORENGINE OIL STORAGEOTHER FUEL SYSTEMCORRECTION TROUBLESHOOTING POINTSPROBLEM CAUSEEngine continues to run TRACTOR - - MODEL NUMBER WET1338B SCHEMATICELECTRICAL REPAIR PARTS2441 DESCRIPTION PART145 CHASSISchassis-pl.lt23 PART 202 DRIVEdrive-saddle24 PART 8546 STEERING1529 PART ENGINE OPTIONAL EQUIPMENT Spark ArresterControl Th/ch Flag 170864SEAT WHEELS & TIRES DECALSlift-rh.1piece3 MOWER LIFTPART 38deck-manual1 MOWER DECKPART SERVICE NOTES LIMITED WARRANTY WARRANTY LIMITED WARRANTIES FOR NEW PEERLESS GEAR POWER TRAIN COMPONENTST E C U M S EH SERVICETHIS ONLY RIDE UP AND DOWN HILL NOT ACROSS HILL 15 DEGREES MAXFOLD ALONG01029-weedeater
Top Page Image Contents