Weed Eater 187637 manual How To Set Up Your Tractor, INSTALL SEAT See Fig, CHECK BATTERY See Fig

Page 7
HOW TO SET UP YOUR TRACTOR

ASSEMBLY

HOW TO SET UP YOUR TRACTOR

INSTALL SEAT (See Fig. 2)

Adjust seat before tightening adjustment bolt.

•Remove adjustment bolt, lock washer and flat washer securing seat to cardboard packing and set aside for assembly of seat to tractor.

•Pivot seat upward and remove from the cardboard pack- ing. Remove the cardboard packing and discard.

•Place seat on seat pan so head of shoulder bolt is positioned over large slotted hole in pan.

•Push down on seat to engage shoulder bolt in slot and pull seat towards rear of tractor.

•Pivot seat and pan forward and assemble adjust- ment bolt, lockwasher and flat washer loosely. Do not tighten

•Lower seat into operating position and sit on seat.

•Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down.

•Get off seat without moving its adjusted position.

•Raise seat and tighten adjustment bolt securely.

SEAT

SEAT PAN

SHOULDER

BOLT

02466

FLAT WASHER

LOCK WASHER

02465

ADJUSTMENT

BOLT

FIG. 2

CHECK BATTERY (See Fig. 3)

•Lift seat pan to raised position.

•If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 amps. (See “BATTERY” in the Maintenance section of this manual for charging instructions).

SEAT PAN

LABEL

FIG. 3

NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.

TO ROLL TRACTOR OFF SKID (See Operation section for location and function of controls)

•Press lift lever plunger and raise attachment lift lever to its highest position.

•Release parking brake by depressing clutch/brake pedal.

•Place gearshift lever in neutral (N) position.

•Roll tractor forward off skid.

•Remove banding holding deflector shield up against tractor.

TO DRIVE TRACTOR OFF SKID (See Op- eration section for location and function of controls)

INSTALL SEAT (See Fig. 2)WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

•Be sure all the above assembly steps have been com- pleted.

•Check engine oil level and fill fuel tank with gasoline.

•Sit on seat in operating position, depress clutch/brake pedal and set the parking brake.

•Place gear shift lever in neutral (N) position.

•Press lift lever plunger and raise attachment lift lever to its highest position.

•Start the engine.After engine has started, move throttle control to idle position.

•Depress clutch/brake pedal into full "BRAKE" position and hold. Move gearshift lever to 1st gear.

•Slowly release clutch/brake pedal and slowly drive tractor off skid.

•Apply brake to stop tractor, set parking brake and place gearshift lever in neutral position.

•Turn ignition key to "OFF" position.

Continue with the instructions that follow.

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents MODEL NO. WET1338B 13 HP 38 Inch Lawn Tractor I. GENERAL OPERATION SAFETY RULESIV. SERVICE Safe Operation Practices for Ride-On MowersNever carry passengers or children even with the blades off 9-13 TABLE OF CONTENTSPRODUCT SPECIFICATIONS CUSTOMER RESPONSIBILITIESKeys UNASSEMBLED PARTSSteering Wheel SeatBEFORE REMOVING TRACTOR FROM SKID ASSEMBLYTOOLS REQUIRED FOR ASSEMBLY TO REMOVE TRACTOR FROM CARTONINSTALL SEAT See Fig HOW TO SET UP YOUR TRACTORCHECK BATTERY See Fig CHECK BRAKE SYSTEM CHECK TIRE PRESSURECHECK DECK LEVELNESS CHECK FOR PROPER POSITION OF ALL BELTSOPERATION KNOW YOUR TRACTOR TO USE THROTTLE CONTROL See Fig HOW TO USE YOUR TRACTORTO ADJUST MOWER CUTTING HEIGHT See Fig TO SET PARKING BRAKE See FigTO TRANSPORT BEFORE STARTING THE ENGINETO OPERATE MOWER See Fig TO OPERATE ON HILLSTO START ENGINE See Fig MOWING TIPSBEFORE EACH USE MAINTENANCELUBRICATION CHART GENERAL RECOMMENDATIONSOPERATOR PRESENCE SYSTEM TRACTORBRAKE OPERATION TIRESTRANSAXLE COOLING BATTERYENGINE V-BELTSENGINE COOLING FINS See Fig CLEAN AIR SCREENAIR FILTER See Fig IN-LINE FUEL FILTER See Fig CLEANINGMUFFLER SPARK PLUGSDepress clutch/brake pedal fully and set parking brake SERVICE AND ADJUSTMENTSTO INSTALL MOWER See Fig TO REMOVE MOWER See FigTO REPLACE MOWER BLADE DRIVE BELT See Fig TO LEVEL MOWER HOUSINGBOTH FRONT LINKS MUST BE EQUAL IN LENGTH FRONT WHEEL TOE-IN/CAMBER TO CHECK AND ADJUST BRAKE See FigTO ADJUST STEERING WHEEL ALIGN MENT TO REPLACE MOTION DRIVE BELT See FigREPLACING BATTERY See Figs. 25 and TO START ENGINE WITH A WEAK BATTERY See FigTO REMOVE WHEEL FOR REPAIRS See Fig TO REPLACE HEADLIGHT BULB TO REMOVE HOOD AND GRILL ASSEMBLY See FigTO ADJUST THROTTLE CONTROL CABLE See Fig TO ADJUST CARBURETORENGINE OIL STORAGEOTHER FUEL SYSTEMCORRECTION TROUBLESHOOTING POINTSPROBLEM CAUSEEngine continues to run TRACTOR - - MODEL NUMBER WET1338B SCHEMATICELECTRICAL REPAIR PARTS2441 DESCRIPTION PART145 CHASSISchassis-pl.lt23 PART 202 DRIVEdrive-saddle24 PART 8546 STEERING1529 PART ENGINE OPTIONAL EQUIPMENT Spark ArresterControl Th/ch Flag 170864SEAT WHEELS & TIRES DECALSlift-rh.1piece3 MOWER LIFTPART 38deck-manual1 MOWER DECKPART SERVICE NOTES LIMITED WARRANTY WARRANTY LIMITED WARRANTIES FOR NEW PEERLESS GEAR POWER TRAIN COMPONENTST E C U M S EH SERVICETHIS ONLY RIDE UP AND DOWN HILL NOT ACROSS HILL 15 DEGREES MAXFOLD ALONG01029-weedeater
Top Page Image Contents