Weed Eater HD13538 manual To Replace Headlight Bulb, Interlocks and Relays, To Replace Fuse

Page 23

SERVICE AND ADJUSTMENTS

REPLACING BATTERY (See Figs. 24 and 25)

WARNING: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connect- ing battery, remove metal bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected first to prevent sparking from acci- dental grounding.

•Lift seat pan to raised position.

•Disconnect BLACK battery cable fi rst then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•First connect RED battery cable to positive (+) terminal with hex bolt and keps nut as shown. Tighten securely. Slide terminal cover over terminal.

•Connect BLACK grounding cable to negative (-) ter- minal with remaining hex bolt and keps nut. Tighten securely.

SEAT PAN

FIG. 24

TERMINAL

KEPS NUT

COVER

 

HEX

BOLT

POSITIVE (RED) CABLE

NEGATIVE (BLACK) CABLE

FIG. 25

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 26)

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

HOOD

HEADLIGHT WIRE

CONNECTOR

01536

FIG. 26

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is nec- essary, see engine manual.

TO ADJUST CHOKE CONTROL

The choke control has been preset at the factory and ad- justment should not be necessary. If adjustment is neces- sary, see engne manual.

TO ADJUST CARBURETOR

Your carburetor is not adjustable. If your engine does not operate properly due to suspected carburetor problems, take your tractor to an authorized service center for repair and/or adjustment.

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents Always Wear EYE Protection During Operation HD13538II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents Contents of Hardware Pack Before Removing Tractor from Skid AssemblyTools Required for Assembly To Remove Tractor from CartonCheck Battery See Fig Check Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor To Transport Reverse Operation System ROSTo Operate Mower See Fig To Operate on HillsTo Start Engine See Fig Before Starting the EngineCheck Engine OIL Level ADD GasolineMowing Tips General Recommendations MaintenanceTo Sharpen Blade See Fig TractorBlade Removal See Fig Transaxle Cooling BatteryEngine BeltsMuffler CleaningClean AIR Screen AIR FilterTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig Belt Removal To Level Mower HousingBelt Installation To Replace Mower Blade Drive Belt See FigTo Check Brake To Check and Adjust Brake See FigTo Adjust Brake To Replace Motion Drive Belt See FigFront Wheel TOE-IN/CAMBER Transaxle Gear Shift Lever NEUTRAL- Adjustment See FigTo Adjust Steering Wheel ALIGN- Ment To Start Engine with a Weak Battery See FigTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsEngine dies when Limited Warranty Policy Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationParts and Service

HD13538 specifications

The Weed Eater HD13538 is a robust and reliable string trimmer designed for efficient lawn care and maintenance. With its impressive features and advanced technologies, this power tool stands out among its competitors, making it an essential item for homeowners and gardening enthusiasts alike.

One of the key features of the HD13538 is its powerful 38cc engine. This engine provides ample power to tackle thick weeds, grass, and underbrush with ease. The robust performance of this trimmer makes it suitable for both small and larger yards, ensuring that users can achieve a well-manicured appearance for their outdoor spaces without the hassle of underpowered equipment.

The weed eater also boasts a lightweight design, weighing in at just around 10 pounds. This is particularly advantageous for extended use, as it minimizes fatigue and allows users to maneuver the trimmer easily. The ergonomically designed handle adds to the overall comfort, making it user-friendly while providing optimal control during operation.

A standout feature of the Weed Eater HD13538 is its innovative 2-in-1 capability, which allows users to easily switch between trimming and edging tasks. The adjustable shaft length offers additional convenience, accommodating users of various heights and ensuring that every job can be completed with precision.

Equipped with a bump feed mechanism, the HD13538 allows for quick line advancement, ensuring that users can keep working without interruptions. Simply tap the trimmer head on the ground, and the line automatically feeds out, providing continuous cutting power and saving time during yard work.

The weed trimmer also features a durable construction designed for longevity. Additionally, the trimmer head is designed to accept various line thicknesses, giving users the flexibility to choose the best option for their specific lawn care needs.

In terms of maintenance, the Weed Eater HD13538 is straightforward. Its simple start system reduces the frustration often associated with starting gas-powered equipment, while the accessible air filter and spark plug make periodic maintenance tasks a breeze.

Overall, the Weed Eater HD13538 offers a well-rounded combination of power, ease of use, and durability. Its advanced features and technologies cater to the needs of both casual gardeners and diligent landscapers, making it a top choice for anyone looking to maintain a tidy outdoor space.
Top Page Image Contents