Weed Eater 96018000100, 435073 To Adjust Steering Wheel Alignment, Front Wheel TOE-IN/CAMBER

Page 22

SERVICE AND ADJUSTMENTS

TO ADJUST STEERING WHEEL ALIGNMENT

If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble per instructions in the Assembly section of this manual.

FRONT WHEEL TOE-IN/CAMBER

The front wheel toe-in and camber are not adjustable on your tractor. If damage has occurred to affect the front wheel toe-in or camber, contact your nearest authorized service center/department.

TO REMOVE WHEEL FOR REPAIRS (See Fig. 22)

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

RETAINING WASHERS

RING

AXLE

COVER

SQUARE KEY (REAR

WHEEL ONLY)

Fig. 22

TO START ENGINE WITH A WEAK BATTERY (See Fig. 23)

WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the Maintenance section of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

WEAK OR DEAD

FULLY CHARGED

BATTERY

BATTERY

 

Fig. 23

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents 960180001 ModelGeneral Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceGeneral Service IV. TowingTable of Contents Seat Unassembled PartsSteering Wheel Keys Slope SheetTo Remove Tractor from Carton AssemblyTools Required for Assembly Before Removing Tractor from SkidInstall Seat See Fig To Check Battery See FigCheck for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Operate on Hills Reverse Operation System ROSTo Operate Mower See Fig To TransportADD Gasoline Before Starting the EngineCheck Engine OIL Level To Start Engine See FigMowing Tips Maintenance Lubrication ChartBlade Care BatteryTractor Blade Removal See FigEngine Engine Cooling System See CleaningIN-LINE Fuel Filter See Fig To Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig To Level Mower Housing To Replace Mower Blade Drive Belt See FigTo Check Brake Transaxle Gear Shift Lever NEUTRAL- Adjustment See FigTo Replace Motion Drive Belt See Fig Weak or Dead Fully Charged Battery To Adjust Steering Wheel AlignmentTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight BulbFuel System StorageOther Engine OILTroubleshooting Points Problem Cause CorrectionExcessive Limited Warranty Service Notes Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service

435073, 960180001, 96018000100 specifications

The Weed Eater 96018000100 is a versatile and powerful trimmer designed for homeowners and professionals alike. Known for its efficiency and reliability, this model is a part of Weed Eater's commitment to provide quality outdoor power tools that make yard work easier.

One of the key features of the Weed Eater 96018000100 is its lightweight design, which allows for easy maneuvering and reduces user fatigue during extended use. Weighing in at just over 10 pounds, it offers a balance that is perfect for trimming around flower beds, sidewalks, and hard-to-reach areas. The ergonomic handle design further enhances user comfort, making it suitable for users of varying heights.

Power is critical when it comes to outdoor tools, and the 96018000100 does not disappoint. This model is equipped with a robust 25cc two-cycle engine, providing more than enough power to tackle thick weeds and overgrown foliage. The engine operates efficiently, offering reliable performance while simultaneously ensuring low emissions. This eco-friendly approach aligns with current environmental standards, making it suitable for eco-conscious consumers.

Another standout feature of the Weed Eater 96018000100 is its easy-to-load spool system. The Rapid Reload system allows users to quickly and efficiently load new line without the hassle of disassembling the trimmer head. This innovative design significantly minimizes downtime and enhances productivity, making it a favorite among both seasoned gardeners and weekend warriors.

In terms of cutting capabilities, the 96018000100 boasts a 17-inch cutting width, allowing it to cover more ground with each pass while still delivering precise cuts around edges and hard surfaces. Additionally, the trimmer features an adjustable head, giving users the ability to tilt and reach hard-to-access spots with ease.

Safety is another crucial aspect of the Weed Eater's ethos. The model includes safety features such as a protective guard that minimizes the risk of debris being thrown towards the user while operational. A safety switch also prevents accidental starts, ensuring that this powerful tool is safe for all users.

In conclusion, the Weed Eater 96018000100 merges innovative technology with powerful performance, making it an essential tool for anyone looking to maintain their outdoor space effectively. With its lightweight design, powerful engine, and user-friendly features, it stands out in its category as a reliable and efficient choice for lawn care enthusiasts.
Top Page Image Contents