HOW to Start Your Unit, Operating Position

SIf engine does not stop, move choke to the FULL CHOKE position.

Engine

Choke Lever

ON/STOP

Switch

FULL HALF OFF

HOW TO START YOUR UNIT

WARNING: The trimmer head will turn while starting the engine. Avoid any con- tact with the muffler. A hot muffler can cause serious burns.

STARTING A COLD ENGINE (or a warm engine after running out of fuel)

Starting Position

1.Set unit on a flat surface.

2.Slowly press the primer bulb 6 times.

3.Move choke lever to the FULL CHOKE posi- tion.

4.Squeeze the throttle trigger fully and hold through all remaining steps.

Starter Handle

Choke

Lever

engine still doesn’t start, it is probably flooded. Proceed to STARTING A FLOODED ENGINE.

8.Once the engine starts, allow it to run 10 seconds, then move the choke lever to the OFF CHOKE position. Allow the unit to run for 30 more seconds at OFF CHOKE be- fore releasing the throttle trigger.

NOTE: If engine dies with the choke lever in the OFF CHOKE position, move the choke lever to the HALF CHOKE position and pull the rope until engine runs, but no more than 6 pulls.

STARTING A WARM ENGINE

1.Move the choke lever to the HALF CHOKE position.

2.Squeeze and hold the throttle trigger. Keep throttle trigger fully squeezed until the engine runs smoothly.

3.Pull starter rope sharply until engine runs, but no more than 5 pulls.

4.Allow engine to run 15 seconds, then move the choke lever to OFF CHOKE.

NOTE: If engine has not started, pull starter rope 5 more pulls. If engine still does not run, it is probably flooded.

STARTING A FLOODED ENGINE

Flooded engines can be started by placing the choke lever in the OFF CHOKE position; then, pull the rope to clear the engine of ex- cess fuel. This could require pulling the starter handle many times depending on how badly the unit is flooded.

If the unit still doesn’t start, refer to TROUBLESHOOTING TABLE or call 1-800-554-6723.

OPERATING INSTRUCTIONS

OPERATING POSITION

ALWAYS WEAR:

Eye Protection

Muffler

Long Pants

Primer Bulb

5.Pull starter rope handle sharply until engine sounds as if it is trying to start, but do not pull rope more than 6 times.

6.As soon as engine sounds as if it is trying to start, move choke lever to HALF CHOKE position.

7.Pull starter rope sharply until engine runs, but no more than 6 pulls.

NOTE: If the engine doesn’t start after 6 pulls (at the HALF CHOKE position), move the choke lever to the FULL CHOKE position and press the primer bulb 6 times. Squeeze and hold the throttle trigger and pull the starter rope 2 more times. Move the choke lever to the HALF CHOKE posi- tion and pull the starter rope until the en- gine runs, but no more than 6 pulls. If the

Heavy Shoes

Cut from your right to your left.

WARNING: Always wear eye protec- tion. Never lean over the trimmer head. Rocks or debris can ricochet or be thrown into eyes and face and cause blindness or other serious injury.

Do not run the engine at a higher speed than necessary. The cutting line will cut efficiently when the engine is run at less than full throttle. At lower speeds, there is less engine noise and vibration. The cutting line will last longer and will be less likely to “weld” onto the spool.

Always release the throttle trigger and allow the engine to return to idle speed when not cutting.

530086922 specifications

The Weed Eater 530086922 is a powerful and efficient string trimmer designed for homeowners and gardening enthusiasts looking for a reliable tool to maintain their lawns and gardens. With its robust features and user-friendly design, this tool makes yard work easier and more effective.

One of the standout features of the Weed Eater 530086922 is its lightweight and ergonomic design. Weighing in at just over 10 pounds, it is easy to maneuver, allowing users to tackle even the most challenging terrains without feeling fatigued. The adjustable handle provides comfort and reduces strain during extended use, making it ideal for those who spend a lot of time maintaining their outdoor spaces.

The trimmer is equipped with a powerful 25cc two-cycle engine that delivers impressive cutting performance. This engine allows the Weed Eater 530086922 to efficiently slice through tall grass, tough weeds, and overgrown brush, making it suitable for various landscaping tasks. Its easy-start technology minimizes pull effort, ensuring that users can start the trimmer with minimal hassle.

The 530086922 features a dual-line bump feed head that allows for quick and easy replacement of trimmer line. This method ensures uninterrupted trimming, saving time and increasing productivity. The adjustable cutting width provides flexibility, enabling users to switch between a wider cut for quick jobs and a narrower cut for precision work around flower beds and trees.

Another significant aspect of the Weed Eater 530086922 is its limited emission technology. Designed with environmental concerns in mind, it operates efficiently while minimizing harmful emissions. This commitment to reducing the environmental impact makes it a responsible choice for the eco-conscious gardener.

Durability is another characteristic that stands out in the Weed Eater 530086922. Constructed with high-quality materials, it is built to withstand the rigors of outdoor use. The trimmer is also designed for easy maintenance, ensuring it can be kept in excellent working condition with minimal effort.

In summary, the Weed Eater 530086922 is an exceptional string trimmer that combines power, efficiency, and ease of use. With its lightweight design, reliable engine, adjustable features, and eco-friendly technology, it is an excellent addition to any homeowner's landscaping toolkit. Whether you're maintaining your lawn or tackling overgrown areas, this trimmer is engineered to meet your gardening needs effectively.