SUPPORT
POST
f
RETAINER
SPRING
REAR
MOUNTING
BRACKET
SUPPORT
BRACKET
PIN
FIGURE 10
SUPPORT
POST
ELBOW
I
5116 HEX
BOLTS
FORMED WAI
ELBOWI
SUPPORT
END PLUG _" _ ELBOW SHIELD
TUBE
_"_ LOCKNUTS
FIGURE 11
5.Assemble the support post to the rear mounting bracket (Fig. 10) using support bracket pin and re- tainer spring. Retainer spring shown furl size below. Support post, latch pin and retainer spring furnish- ed with bagger.
6.Mount elbow support tube to support post (Fig. 1 1) using: two 5/16 hex bolts and two 5/16 Iocknuts {shown full size below}. NOTE: Position elbow sup- port tube as shown in Fig. 1 1, Tighten securely, Elbow support tube and hardware furnished with bagger.
©
7.Install end plug (Fig. 1 !) on elbow support tube. End plug furnished with bagger.
8.Mount the elbow retainer and the elbow shield to
the elbow support tube (Fig. 1 1) using: two form- ed washers and two 5/16 Iocknuts {shown full size
below). NOTE: Do not tighten. Elbow retainer, elbow shield and hardware furnished with bagger.
©
. Slide elbow through elbow'retainer (Fig. t2 - Inset).
Secure elbow to elbow retainer using: two clips, two screws, two washers and two acorn nuts.
NOTE: Mount clips in holes located 2 - I/2" from edge of elbow. Hardware shown full size below, Heads of screws and flat washers mount to the in-
side of elbow. Position clips with closed end of clip facing tube opening as shown in Fig. 12 - Inset.
Tighten securely. NOTE: Tighten hardware assembled in step 8. Elbow and hardware furnish- ed with grass catcher.
10.Flip seat forward.